There is no p1781 code for dodge, http://www.datsc.com/tabid/122/OBD-Error-Code/P1781/Diagnostics/Dodge/Default.aspx
SOURCE: what does codes p0645 and p0481 mean on a 2004 dodge intrepid?
P0645 A/C Clutch relay circuit
P0481 high speed fan control relay circuit
SOURCE: just got car dont know what codes mean
po 300 is multible missfire p1684 is battery interrupted or disconectedat some point. if it runs bad have your cam sensor checked.!!
SOURCE: 2004 chevy aveo that the
P0128 - the thermostat may be stuck open or has anyone
put a colder thermostat in the car,because once it starts to get cold
it will throw a SES with a colder then stock thermostat. Replace the Thermostat should fix this problem.
PO700 is a code telling you there are codes in the TCM of some late
model cars where the Transmission control module has been removed from
the PCM the vehicles main computer , and basically it happens when the
TCM has a issue within itself or the transmission that sets a code and
it sends a request for the PCM to illuminate the SES or CHECK engine
light. To get at the TCM codes requires in most cases the most up to
date scanner software purchased after the cars model year and as of yet
is still a little iffy. Standard OBD11 scanners will generally not be
able to see these codes.
P1781 is set during engine
start up when the ECM & TCM do not communicate properly during
initial power up. It will only illuminate the service light if the
condition occurs in 2 consecutive start cycles, but the DTC will be
stored in the failure records after the first cycle.
Replace the Thermostat and go to a transmission shop that can read the DTC codes with a scanner and reset the ECM for clear the codes. Most Transmission shop will do that free of charge, if not turn the Ignition key's to the on position and and pull the ECM fuse out for 30 seconds and then place it back in. Turn the ignition keys to the off position for 10 seconds and then start the car, the engine may stall but let it. Just start the engine again, the ECM is just relearning the engine and go for a test drive. This will clear all the DTC history in the ECM like the day it cam off the assembly line. Good luck and keep me posted, be glad to answer ay more question.
SOURCE: CDs are stuck in the default cd player of 2001 Dodge Intrepid.
The first step is turning the car off. Then before turning the key back on, push and hold the Eject button then turn the ignition on. If the CD fails to eject then you can use a old CD and try to insert it into the CD Player, just as it try's to take your second CD pull it out and hit the Eject button again. This will usually get a Dodge CD player to Eject.
If this fails then the CD player must be removed and a manual eject can be performed.
356 views
Usually answered in minutes!
×