At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: I am trying to find timing chain marks for 2005 jeep...
O lord very difficult engine to time man. word of advise don't remove the primary oil pump chain. there are no marks. line the bigger oil pump sprocket DOT to 12 oclock if you have the chain lock tool this makes life a lot easier. Both of the cam sprocket have a V6 mark on it they should be at 12 oclock. If everything line up like that u are golden. Hope this helps. If you need step by step instrutions I will help. Rate me please
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
? 5:26
https://www.youtube.com/watch?v=2ba-gH0gadg
Dec 21, 2014 - Uploaded by TheBGravit
While replacing a bad fuel pump I believe I found the cause of a P0442 Error code. I was able to repair the ...
CarGurusMay 27, 2009 - My jeep Liberty 2009 does the same the Dashboard showed a code of cylinder .... i have a jeep liberty 2006 with the # 5 cylinder misfire. i replaced the sparks... I have a 2005 Jeep Liberty 6 cylinder, engine light came on scaned the ... 2002 jeep liberty camshaft posistion sensor error code p0340 5 answers.
Recently got a second hand 2005 Jeep Liberty Sport. Everything worked fine ... #5intake valve seat dropped and held open the intake valve. 2008 Jeep Liberty.
what car, XJ ended in 2001
or the KJ ?
Model years 2002-07), also known as the Jeep Liberty in North America
or grand Cherokee.?
what are you doing, we can';t guess that here?
CAM timing?
spark timing,?
the Balance shaft?
what country is this an Export jeep.
eg: , i removed my engine heads and......
eg: i removed my coil pack and did not mark the wires.
the 3.7l has no spark timing, its FIXED. by 3 ways.
so....?? what job>?
ill answer now for 3.7L 2005
our 3.7 (usa our)
COPS , that is , 6 coils over plugs. hard wired, so firing order is ECU controlled, 100%
that leaves the pulley marks, (the book shows no adjustment possible)
quote Ignition timing is controlled by the Powertrain Control Module (PCM). No adjustment is possible.
Unquote
so my guess, wild you must be fiddling cams?
are you?
the Timing CHAIN? if yes, say so
or better why not log in to alldata.com
and read that, then ask questions not clear in the FSM or there.
my guess on cam
is step 11a you get stuck
The idler sprocket must be timed to the counterbalance shaft drive gear before the idler sprocket is fully seated.
that v6 engine has no timing adjustment. it has a timing chain. so if there is a stretch on chain, it must be replaced according to factory service manual. only thing you need to watch is to mark the position of gears before you remove chain. also timing of ignition is maintained by engine controller. if you need a custom setup you need chip tuning for that.
Confirm engine please. Timing chain already? what happened?
×