My right blinker is not working on either the front or back of my vehicle. The left side works and the hazards work on both left and right side. It doesn't indicate anywhere in the vehicle that the blinker is working.
You'll need to find a wiring diagram an component location chart to check this out . Here is a diagnostic flow chart for trouble shooting this problem ! Do you know how to use a voltmeter ?
Is the voltage within the specified range?
Do the appropriate turn lamps light without flashing?
Refer to Wiring Repairs in Wiring Systems.
Refer to Wiring Repairs in Wiring Systems.
DEFINITION: This table diagnoses inoperative turn signals on one side. It assumes that the cornering lamps, hazard lamps, and turn signals on the other side all operate properly.
1
Did you perform the Exterior Lights System Check?
--
Go to Step 2 - yes
Go to Exterior Lights System Check - no
2
?€¢
LH: cavity C (ORN)
?€¢
RH: cavity B (BLK)
10-15 V
Go to Step 3 yes
Go to Step 5 no
3
Connect a fused jumper between the appropriate turn signal flasher connector cavities:
?€¢
LH: cavity C (ORN) to cavity D (YEL)
?€¢
RH: cavity B (BLK) to cavity F (TAN)
--
Go to Step 4 yes
Go to Step 6 no
4
Replace the turn signal flasher. Refer to Hazard and Turn Signal Flasher Replacement .
Is the repair complete?
--
Go to Exterior Lights System Check
--
5
Repair the open in the appropriate circuit:
?€¢
LH: CKT 57 (ORN) between S200 and the turn signal flasher
?€¢
RH: CKT 58 (BLK) between S201 and the turn signal flasher
Is the repair complete?
--
Go to Exterior Lights System Check
--
6
Repair the open in the appropriate circuit between the turn signal flasher and the IP fuse block:
?€¢
LH: CKT 685 (YEL)
?€¢
RH: CKT 686 (TAN)
Is the repair complete?
--
Go to Exterior Lights System Check
873 views
Usually answered in minutes!
×