After i install the new fuel filter do i have to press the fuel reset button? if so where is it located

Dodge Caravan does not have a reset button.

No such button. Who told you that?

Ford Focus 2000-05
Removal & Installation

Print

1. Before servicing the vehicle, refer to the Precautions Section.
   NOTE The fuel filter is located underneath the vehicle in the area of the rear suspension.
   
2. Relieve the fuel system pressure.
3. Raise the vehicle.
   NOTE To remove the lines, press the quick-release tabs on the connectors.
   
4. Remove or disconnect the following:
   
   Evaporative Emissions (EVAP) vapor line Fuel filter lines Fuel filter and bracket assembly Fuel filter
   
   

   Fig. Location of fuel filter and lines.
   
   

To install:

1. Install or connect the following:
   
   Fuel filter Fuel filter and bracket assembly Fuel filter lines EVAP vapor line
   
2. Start the engine and check for leaks.

1. Before servicing the vehicle, refer to the Precautions Section.
   NOTE The fuel filter is located underneath the vehicle in the area of the rear suspension.
   
2. Relieve the fuel system pressure.
3. Raise the vehicle.
   NOTE To remove the lines, press the quick-release tabs on the connectors.
   
4. Remove the fuel filter bolt and remove it from the bracket.
   
   

   Fig. Location of fuel filter and lines.
   

To install:

1. Position the fuel filter into the bracket. Ensure the fuel flow direction is properly aligned.
2. Install and tighten the fuel pump bracket bolt.
3. Lubricate the fuel tube fittings with clean engine oil. Align the fuel tube fittings and press together until a click is heard and then pull on the fittings to make sure they are fully engaged.
4. Start the engine and check for leaks

For vehicle with steering wheel conrtols ,to reset the fuel,Press and hold the select button for five seconds while the fuel filter life message is displayed . The message will appear on the DIC for ten second
For vehicle without steering wheel control ,do the following, without pressing the pedals,turn the ignition key to the on position without starting the engine ,wait five seconds,completely press the the brake and the accelerator pedal simutaneously, and hold for ten seconds ,the system is now reset ,
The next time the engine is started the message will no longer be displayed, Always reset after a fuel filter change

No reset, you need a new fuel pump. Do yourself a favor and replace the fuel filter also.

The fuel filter is located in the engine compartment, at the inlet line to the fuel rail. Be sure to relieve the pressure in the system first by removing the fuel pump fuse and cranking the engine a few times. When installing the new filter use new O-rings and tighten the lines to 22 ft. lbs.

it should be underneath the car, right under where the fuel cap is, it will be between there and the tank.

need to bleed the line should be a bleeder on the line ontop of the engine

you might look into the fuel pump reset switch or the fuel filter might be clogged