How to remove driver side door panel on Mitsubishi Endeavor 2004

https://www.justanswer.com/mitsubishi/8bp9q-mitsubishi-2008-mitsubishi-endeavor-won-t-start.html
This link may help .... shows both fuel relays in the passenger compartment, with driver door open ... the panel should be at the end of the driver side dashboard.
This link also goes over a bunch of issues that the owner had with his car not starting ... which may be why you are looking for the relays also.
Anyway...good luck with your troubleshooting

I just do them. Done to many. So this is generic. Look for plugs around the door handle, arm rest, and by the mirror. Pop them out, screws behind them. Screws can also be around the perimeter of the door panel. Also behind door reflectors. Once out lift up on the panel. If it doesn't go up, use a screw driver, start at the bottom and pop it off.

The nut and trim cover I would think. Whats on the drivers side? Why are you replacing it?

go to www.reliable-store.com you will get
all info and solutions there definitely

you need to take off the door panel and there are pins, rods, and cables. so remove the rod and pin for the door handle and it should pop out.

Maybe try alldata.com, because on my online resource for the 2004 Mitsubishi Endeavor, there is no information on body work.

One could get the part from the salvage yard and look for the bolts like one would do for a GM car

One may have to remove some plastic parts to get at the fasteners.

Also, if there are cables for moving the mirror from the inside, then that should be considered, as well.

Also, if the mirror is heated, that should be considered.
---
(I got this off of Wiki Answers)
Very easily. Open the door, find two rubber circular boots right behind the
mirror. Take them off to expose the 2 bolts that hold the mirror on. Take the
bolts out and unplug the wire. Reverse these steps to install, hole this
helps...

There are three small bolts holding the driver's side mirror on. Two can be
accessed by opening door and removing the two circular rubber boots seen on the
upper end of the door . To access the third bolt you will need to remove the
door panel. you will need a forked driver to help remove the door panel. It can
be bought at any auto parts store. It has a flat Y shaped head that can be
inserted along the lateral and bottom edge of the door panel to pop it way from
the door frame. There are three screws holding the door panel on. Two under the
door handle and one behind the door latch. Then the door lifts up and off. Make
sure you have the window down before you take the panel off because you cannot
access the third bolt unless it is. You will have to unplug the electrical
connects that power the controls on the door handle to completely remove the
door panel. After you remove the panel there will be a hole in the upper right
hand door frame, possibly covered by a black patch. Beneath this is the third
bolt. you will also need to disconnect the light from inside the door frame
before you will be able pull the mirror off. There is a large rubber boot oval
shaped that you can pull out and you will see the electrical connection for the
mirror inside the hole on the right.


Good luck on this repair.

do you have a sunroof?

if not is your heater working? busted heater matrix otherwise

drainage tube should be located behind the drivers side kick panel

Does this not open from inside or outside or both.
If it opens from the inside and not the outside look at the door opening near the latch. Look for the small lever "child-lock" just move the lever in the oposite direction.
If the door doesn't open from inside or outside I would ask has anyone try to unlock the car using a "slim-jim" if so they may have caused the lock rod to come off the latch on the inside. You'll need to remove the door trim panel and see the the rod has come off. With any luck it will just pop back on if the nothing is broken.

Hi. While looking into your question I came across another posting of the same question for a 2004 Mitsubishi Endeavor and I believe it could help you. I put it in a link below. The instruction are basically the same. I hope this helps. Let me know if I can be of anymore assistance.

2004 Mitsubishi Endeavor Headlight Replacement

Remove Endeavor Rear Panel

On the side panel there is a cargo hook with a 10mm bolt. Take that bolt out. On the floor panel there are 2 cargo hooks -- also 10mm. Take them out and remove floor panel. Fold seat forward and you should have access to 5 or 6 bolts -- also 10mm. Remove them then pull the panel out slightly and disconnect the cig ligthter and that should solve your issue.