SOURCE: 1993 Oldsmobile Cutlass Ciera won't turn over (crank)
First step is see the Condition of the oil.
Them you need to see if the ENGINE is NOT LOCKED UP.
To Do that, you will need a Rachet and Socket to Try TURN the CRANKSHAFT pulley by Hand.
If you are ABLE to Rotate,
And the Battery is good, Check all the Connection from the BATTERY to the STarter motor,
And the Ground Cable. From battery To the Chassis and the Bolt at the Transmission.
But if you are Unable to TURN over the Crankshaft Pulley.
The Engine is Locked up.
And will need to take a Opinion of a Mechanic .
To be sure Of the problem and the condition that may affect to the ENGINE went damaged.
I hope this help on your problem.
Thank you for use fixya...
SOURCE: 94 olds cutlass ciera headlight lens
First you have to remove the corner turn signal and grill. Both should be held on with just some hex screws (3 in signal, about 6 in grill). Then you should see 4 black bolts. Unscrew those and the assembly comes right off. : )
SOURCE: The windows in the 95 oldsmobile cutlass ciera won't work at all
maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.
SOURCE: Changing spark plugs on a 1995 Oldsmobile Cutlass Ciera
ALL YOU NEED IS 3/8 RATCHET WITH A 5/8 SPARK PLUG SOCKET.YOU NEED EXTENSIONS AND UNIVERSAL JOINTS TO GET TO HARD TO REACH PLACES.YOU NEED A SPARK PLUG GAUGE.YOUR SPARK PLUG GAP SETTING WILL BE. 0.060 THAT WILL BE FOR THE 2.2 AND 3.1 ENGINES.
Testimonial: "Thank you very much for your advice and time!"
94 views
Usually answered in minutes!
×