As I said all new coil packs.
SOURCE: P0136, P1131, and P1151 codes on Ford Expedition 2000 4.6L
Your auto has four O2 sensors. Two upstream and two downstream; With two banks. Bank 1, sensor 1...and bank 2, sensor 1 are the two upstream (exhaust manifold before the catalytic). Bank 1, sensor 2 and bank 2, sensor 2 (other side of catalytic)
Code 1131= upstream; bank 1..sensor 1
Code 1151= upstream; bank 2..sensor 1
Code P0136 (generic code) bank 1..sensor 2 (questionable)
I wouldn't spend the money to purchase 3 sensors. Highly unlikely all three are bad; Cost is about $40/ ea.
Since there isn't a code for the cat's themselves, I would suspect the O2 circuit is malfunctioning. The rough idle is another clue.
Take an ohmmeter set it on X10 scale and measure the resistance from engine to body and body to negative post on battery terminal. You should read zero ohms (full needle deflection). If you do go buy two upstream O2 sensors. If you read
open or a high resistance run two straps from eng. to body...and body to neg.batt. post.
FixYaWIZ................saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
P0316 crankshaft position sensor, camshaft position sensor, or a wiring issue. Since this code indicates a start up misfire, pay attention to items which may expand or contract when cold (if the code sets when the engine is cold), or hot (if the code sets on a hot restart).
If you have other misfire codes that pertain to individual cylinders, you should attend to them first P1151 has a huge list of things that it can be, But included in that list is the camshaft position sensor , po1131 is the same thing, all building up to your car is running lean , so I'd do the sensor (cam) and check timing,,
86 views
Usually answered in minutes!
×