Where is the transmission fluid located to add fluid in a 95 Isuzu trooper

SOURCE: how do I check the transmission fluid of my 98 Isuzu trooper ?

In fact, you can. The large transmission pan has two plugs in the bottom. The higher one is a fill plug. The lower one is a drain plug. The proper procedure for checking the level is: A) Drive vehicle until transmission reaches operating temperature (go for a 30 min drive). B) Park vehicle and apply emergency brake, run gear selector through all gears (engine running, pausing 5 sec.'s in each gear) from Park, down, and back to Park (very important to be in park when checking level). C) Immediately remove the upper fill plug and check level with your finger, it should be just up to the hole, fill as necessary. NOTE: If more than a dribble of fluid drains out when you first open the fill plug then it was overfilled or the procedure was not followed. Use a catch pan under the hole just in case. Filling of the fluid is by means of a small pump and hose, commonly found at auto parts stores.

SOURCE: 2000 isuzu trooper 4wd dont

there is no holding tank......on the trans pan there are 2 removable pluck.....the one on the bottome drains fluid......the one higher up on the pan is where u add .......truck has to be running in park and level......has to be warmed up and idling.....remove upper plug....when fluid dribbles out its full.

SOURCE: 1995 isuzu trooper manual transmission

Hello smeet3992: The transmission uses 5w-30 for tempretures up to 95 degreese in tempreture. Uses 15w-40 for all tempretures greater then 50 degreese. If you are in an area that has extreme fluctuation in tempretures I would use the 15w-4o engine oil. I also senrt a picture of where to check the oil at. Make sure you pull the right plug. The reverse idler pin has the same size bolt head.
Please rate the quality of your answer as this helps to ensure you recieved the information you asked for. Thank You for using FixYa. Roger

SOURCE: 2000 ISUZU TROOPER WITH AUTO TRANSMISSION. CHECK

If the fluid is up -
it could be a vacume loss or the shifting module..
The shifting module is what tells it to shift - and it is controled by vacume pressure..

SOURCE: How to check transmission fluid on my 2000 Isuzu

Transmission fluid level get's check from the transmission pan. there is two drain plug's on the transmission pan, the lower one is to drain fluid and the up most one on the pan is to check level, with engine running remove the up most plug if transmission fluid start to come out it's ok.