Www.ask.com/1992/Plymouth/Sundance/2.5L/service-manual/
/troubleshooting-guide/
/wiring_diagrams/
/air-vent-layout/diagrams/
/door/diagrams/layouts/
/air-condition-layout-diagrams/
/ventilation diagrams/
/heat-duct-layouts-diagrams/
/what every you want or need/
SOURCE: 1992 es 300 lexus heater is blowing cold
. Yes it could. some are vacuum powered, cable powered (mechanically) or electric powered. If the valve does not open. The hot water will not get to the heater core. It could also be the thermostat not opening.
SOURCE: Adding freon to air conditioner
from the compressor there is two lines coming
from the back side, follow the line that goes
in to the front condenser thats your low side.
G
SOURCE: i want to recharge the air conditioner on a 1992 crown vic
find your evaporator inlet outlet lines on the fire wall usually near heater core inlet outlet lines. then follow both lines until you find the one that goes to the compressor. that is your low side and the port should be on there
SOURCE: i need all the engine diagnostic codes for a 94
11 Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking
12 Direct battery input to PCM/ECM was disconnected within the last 50 key-on cycles (normal)
13 No change in MAP from start to run
14 MAP sensor voltage too low
15 No vehicle speed sensor signal
17 Closed loop temp not reached or engine cold too long
21 02s sensor problem (oxygen sensor), upstream or down stream
22 Engine coolant temp sensor out of range
23 Intake air temp sensor out of range
24 Throttle Position sensor out of range
25 Idle air control motor circuits, target idle not reached (+/- 200),vacuum leak found
27 Injector control circuit
31 Evap purge flow monitor failure or evap solenoid circuit
32 EGR system failure
33 A/C clutch relay circuit
34 Speed control Solenoid circuits
35 Rad Fan control relay circuit
37 Torque converter clutch solenoid CKT or park/neutral switch failure
41 Generator field not switching properly
42 Fuel pump relay control ckt, Auto shutdown relay control ckt, No ASD relay output voltage at PCM, Fuel level sending unit volts out of range, Fuel level unit No change over miles
43 Multiple/ single cylinder misfire
44 Battery temp sensor volts out of range
46 Charging system voltage too low
51 Fuel system lean
52 Fuel system rich
53 Internal control failure
54 No Cam signal at PCM
55 End of error messages (If you get this only, no errors were found)
62 PCM failure SRI mile not stored
63 PCM Failure EEPROM write denied
64 Catalytic Converter Efficiency Failure
65 Power steering switch failur
SOURCE: drivers side windshield wiper not moving
The bolt that holds the wiper on is loose. There is a little plastic cap at the other end of the wiper arm, the side away from the wiper blade. Remove the cap and tighten the bolt. That should get it going again.
259 views
Usually answered in minutes!
×