SOURCE: 93 mazda mx6 (v6) no spark.
Coil resistance is not a good way to determine if the coil is good or bad. It might still need replacing. Check to see if your getting a pulse signal to the coil. You can do this by hooking a milivolt test light to the trigger wire and ground. If it doesn't flash as you crank the motor, check out your pickup coil in the distributor. Some of them you can change. Some you have to replace the entire distributor. Sometimes oil will leak into the distributors on certain models which use an optical pickup. If this is the case, change the seal to fix the oil leak and GENTLY clean the optical sensor and photo wheel.
SOURCE: mx3 idle
your throttle body is dirty and needs to be cleaned- also, you might want to check the spring and the various parts on the throttle itself for wear and tear.
the intake for air and the flutter wing could also be hanging up inside the air intake
SOURCE: i have a 93 mazda mx3 4cyl 5sp. it is really hard to put in gear
sounds like the clutch is going to need replacement and while there you should change the slave cylinder too
SOURCE: What size is the spark plug gap on a Mazda MX3 V6 1840cc please?
1.0 - 1.1 mm ( 0.040 - 0.043 inch )
NGK BKR5E - 11
NIPPON DENSO-- K16PR-U11
SOURCE: 93 mazda mx3. has spark, gas, air.. but its just
93 Mazda mx3 if was running and died or trend off and then will not start it might be the engine coolant temp sensor located next to the number one injectr It should be a two pronged sensor green at top and should set Codes for it and air temp and mass air flow as well but it is just the engine coolant temp sensor
369 views
Usually answered in minutes!
×