Im assuming you mean vehicle speed not engine speed , if so it's not hard , locate under car where the output shaft (drive) comes out of back of transmission , on drivers side of car move your hand up a few inches till you feel a small electrical connector just ahead of there , that's it!! removes with a 5/16th nutdriver two bolts if lots of fluid comes out hole that's why it went bad in the first place !! the internal seal inside transmission has went bad
Output speed sensor is the same thing. Sending a picture. It unscrews. Look straight down between the radiator and transmission.
Replace speed sensor town and country
SOURCE: location of the speed sensor on 1996 town & country
they are on the front drivers side of the transmisson and have two wires coming off them, there are two one is an input shaft sensor and the other is an output shaft sensor unless you have a 4 cyl van then there is only one sensor please rate -jeff
SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited
do you mean they are sticking?
SOURCE: low speed fan relay for the 2005 chrysler town and country
If you are talking about the cooling fan relay for the radiator there is no low speed and high speed relay. There is only one relay and it is behind the grill revitted to the bumper rail. It is doesnt look like you typical relay.
SOURCE: locassion of output speed sensor on 2003 Town and Country
The input and output speed sensors look identical on the connector side. The one over the solenoid pack is the input, the one closer to the left frame rail or left front wheel is the output sensor. I hope this helps.
SOURCE: where is the speed sensor in town & country
There are 2 speed sensors on your vehicle, an input speed sensor and an output speed sensor. Below is a pic showing the front of your transmission. The input sensor is closest to the engine. Both sensors look the same.
1,633 views
Usually answered in minutes!
×