SOURCE: Is a 2000 Dodge Grand Caravan fuel filler neck usable in a 1999?
yes it will swap and you have to remove it from the bottom of the van remove the screw/clips from inside the filler door and then from underneth disconect the filler tube ti tank and the vent hose to the tank i belive there is a bracket also holding the filler tube to the body with one bolt then it snakes out of the va r insalating is just reverse
SOURCE: need to replace fuel filler neck on 1999 dodge dakota
I just replaced one today. I found this post looking for an answer myself and ended up just going for it. The metal at the end of the plastic hose is a clamp that was compressed with a special tool. Here is what I did.
I cut the compression clamp open with a Dremel and a cut off wheel. Be careful not to cut through to the plastic. I did a little at a time the whole length of the clamp and cut through only at the end about 3mm. I then put a screwdriver in there any was able to pry it up and break the clamp in half since I had cut most of the way through it. Take your time.
With the clamp off it will still be hard to get the metal tubes out. I had badly rusted tubes so I broke them off near the plastic tube and bent the end inside the plastic a little with a hammer. I was then able to pull the vent tube out. On the fill tube I bent it to move it away from the plastic enough to get tin snips in there. I cut it and could then get the tube out.
It looked like there was some kind of rubber ring on the tubes. I used some sealer on the tube when I slid it in the plastic and used regular hose clamps. Make them very tight. You don't want an air leak.
SOURCE: How to remove the fuel
OPEN GAS CAP FLAP THEN YOU NEED TO DRAIN GAS BELOW FILLER NECK.THEN LOOSEN REMOVE SCREWS IN THE GAS CAP FLAP AREA WHERE FILLER TUBE CONNECTS THEN GO UNDERNEATH VAN LOOSEN REMOVE HOSE CLAMPS AND REMOVE THE HOSE AT THE FILLER NECK BELOW THE GAS TANK.SPRAY WD40 AROUND HOSE AREA AT METAL FILLER TUBE STICK OUT GAS TANK.CAREFULLY USE LARGE PAIR OF CHANNEL LOCK PLIERS TO REMOVE WORK HOSE OFF METAL TUBE FROM GAS TANK. IF YOU CANT REMOVE HOSE WITH HANDS.BECAREFUL NOT TO MAKE ANY SPARKS.PLACE RAGS AROUND ANY METAL PARTS TO KEEP CHANNEL LOCKS FROM HITTING METAL MAKING SPARKS.
566 views
Usually answered in minutes!
×