The b 13 code is displayed for you next service with the dealer. It informs the dealer what type of inspection the vehicle will receive along with its oil change. It will be reset by the dealer, however, you can reset it by holding down the push button by the speedometer and then turning on the key till the dash lights come on. Hold the button until the b service light flashes then release it and then push and hold again till the b service light resets
Passenger Knee Bolster Deployment Control (subfault)
SOURCE: 1999 Honda Accord Coupe
See an example
DISASSEMBLY
1.
Remove the suction pipe and the O-ring from the oil pump.
2.
Remove the rear cover with the gasket and pins.
3.
Remove the cam ring.
4.
Remove the rotor and vanes.
5.
Remove the front side plate.
6.
Remove the inner and outer O-ring.
7.
Remove the spring.
When assembling, use a new gasket and O-ring.
8.
Remove the pulley nut with the spring washer.
9.
Pull off the pulley and the woodruff key.
10.
Remove the snap ring using snap ring pliers.
11.
Drive out the pulley shaft with the bearing. If necessary, use plastic hammer
SOURCE: 2005 Honda Accord
behind the inside door handle by removing the inner cover you well find two screws remove them by the inside grab handle on the door there is a small rubber mat remove the mat on the upper right corner is a trim piece it just pops off once the screws and trim is removed use a small screw driver and go below the door panel and wedge it between the panel & door and pull back on the screw driver until you here a pop the door panel is held on by plastic clips :caution--when removing the panel DO NOT YANK ON THE DOOR PANEL. THE INSIDE DOOR HANDLE IS STILL ATTACHE D TO THE DOOR PANEL. if you dont unhook this cable before removing door panel you will break the plastic end of the cable if you break this you will have to replace the cable then this well involve removing the latch because the cable is hooked inside the latch hope this helps
SOURCE: Honda Accord Service Manual
SOURCE: check engine light on on
p2647 is rocker arm actuator A- bank 1 stuck on--- to fix it should be the VTEC oil pressure switch.
That switch will be on the cylinder head. Towards the windshield and passenger's side (I think).
Go to www . hondapartsdeals . com {remove the spaces when typing}
Go to parts, enter your car's info. System: Engine Component Vtec Oil control valve. That diagram should help a lot.
Good Luck.
SOURCE: what does it mean when it lights up to say d3 on
If it means the same thing as my '04 accord it means that the transmission is in 3 speed mode ( no overdrive).
142 views
Usually answered in minutes!
×