1999 Jeep Grand Cherokee Logo
A
Anonymous Posted on Apr 12, 2015

My 1999 grand Jeep Cherokee v6 will crank but it winter stay crank...just replaced the ignition switch.

1 Answer

dimbulb

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Greenhorn:

A rookie expert who has answered 20 questions on their first day.

  • Contributor 43 Answers
  • Posted on Apr 12, 2015
dimbulb
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Greenhorn:

A rookie expert who has answered 20 questions on their first day.

Joined: Apr 11, 2015
Answers
43
Questions
0
Helped
14575
Points
92
  • dimbulb
    dimbulb Apr 12, 2015

    wont crank but cranks perfect, but dont start, or cranks perfect ,runs for 2 seconds and stalls?, is the SKIM light on?

  • dimbulb
    dimbulb Apr 12, 2015

    stay cranked = stays running?

×

5 Related Answers

Anonymous

  • 50 Answers
  • Posted on Jun 10, 2009

SOURCE: 1993 Jeep Grand Cherokee, V6. Oil Pressure Gauge Read High.

it could be the sensor you should look at the oil pressure relief valve

Ad

Anonymous

  • 1 Answer
  • Posted on Jun 23, 2009

SOURCE: 99 Jeep Grand Cherokee Brake light problem

You can adjust the switch by putting your thumbs on either side of the switch plunger and pushing toward the brake lever. The switch shaft will ratchet into the new position which is will then be depressed by the brake lever when it is the brake is not being depressed.

Anonymous

  • 5081 Answers
  • Posted on Oct 11, 2009

SOURCE: shift indicator light 1999 Jeep Grand Cherokee

There are two parts to it, a voltage resistor, and the EL panel itself.

You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.

There are a total of 6 flat screws, and 3 self tapping screws you have removed.

Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.

Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.

Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.

Re-install everything in the opposite order.

Anonymous

  • 124 Answers
  • Posted on Nov 05, 2009

SOURCE: I have a 1999 jeep grand Cherokee larado V6.

The P1391 code indicates that the crank or cam sensor(s) have sent an intermitant code to the ecm. The most common cause for this is loose wiring or debris on the contacts of one of the sensors.

Laurie Schloss

  • 1 Answer
  • Posted on Mar 08, 2010

SOURCE: Replacing water pump on 2000 Jeep Grand Cherokee V6

i have a 2000 grand laredo jeep cherokee that is leaking fliud bad i think it the water pump how do i fix it ??

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a grandcherokee 1999 n i change the ignition switch n now it doesn't stay on no more then 5 sec.what should i do

if you changed the ignition you have the key and switch programed into the computer because the 5 second run is a security item.
0helpful
1answer

96 grand cherokee starter stays engaged

bad starter relay in the PDC fuse box.
or bad ignition switch control output (crank key signal) to relay bad.
then engine may destroy the starter drive, if this keeps happening.
see page 8w-21 (wiring) for exact circuits.
ZJ
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service




old post, but feel your pain.
0helpful
1answer

1999 jeep grand cherokee laredo v6 4x4 won't fire on all 6 cylinders just 4 why?

Plenty of causes. Plugs, valves. rings, numerous electronic/electrical faults. Diagnose vehicle and eliminate problems one by one.
0helpful
1answer

I have a 1999 Grand cherokee V6 replace fuel pump, crank shaft sensor and spark plugs. When you drive it wont shift now. The gas light is on and tank is full. Could you please help with any information...

did it start not shifting after or before changing these parts? also, when you replace the fuel pump , did you replace the whole assembly or just the pump? please repost and i will help
1helpful
2answers

My 98 grand cherokee stalls while driving then has a hard time turning back on. Sparatic problems. I have cleaned throttle body, currently replacing tps sensor, fuel pump is working, air filter is...

either a pick up crank sensor ,or a dodgy fuel pump .But it could be evan a ECU unit playing up or factory immobilisor .hope its something cheap and easy for you though
0helpful
1answer

I have a 1999 jeep grand Cherokee larado V6.

The P1391 code indicates that the crank or cam sensor(s) have sent an intermitant code to the ecm. The most common cause for this is loose wiring or debris on the contacts of one of the sensors.
1helpful
1answer

2001 Jeep Grand Cherokee 4.7L crank no start

easy trouble shoot easy fix ! check to see if its getting fire if not replace the crank sensor it will fire right up common problem with the jeeps . Hope this helps you out !!!
11helpful
3answers

99 Jeep Grand Cherokee Brake light problem

You can adjust the switch by putting your thumbs on either side of the switch plunger and pushing toward the brake lever. The switch shaft will ratchet into the new position which is will then be depressed by the brake lever when it is the brake is not being depressed.
0helpful
2answers

1999 jeep cherokee

Your daytime running light module is burned out. Unplug or replace it. Usually its located near/ behind the passenger side headlight.
Not finding what you are looking for?

83 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...