Error Code U0019 on a HYUNDAI SANTA FE MODEL YEAR 2004 ENGINE : DIESEL

2001 Hyundai Santa Fe , S.Korean car,
no country told (you ) or what engine is there, gas/diesel and displacement (size)
the classic easter egg hunt, (it's not bad leave it be)
post problems first
check fuses and scan the PCM, obd2, usa scan tool if is USA>?


2.7L V6 - Gas <<< this? answering for only this ME (guessing engine) or 2.4L?
2001-2003 Hyundai Santa Fe - ECM - Hyundai

ECM. ELECTRONIC CONTROL UNIT. Engine Control Module.

Stock Code??? 3912138170 This part is compatible with 1 vehicle(s) matching 2001 Hyundai Santa Fe LX Sport Utility 5-Door 2.7L 2656CC V6 GAS DOHC Naturally Aspirated. and must be programmed before use. (new /used , replaced)

this

https://youtu.be/19Jl0c8wXeg

i hear folks had HVAC leak water to the ECU below and wrecked it.
super bad location that.

and this

https://www.justanswer.com/hyundai/6l5lk-hyundai-santa-fe-change-ecu-2003-hyundai-santa.html


the car may have
BCM, body.
PCM (TCM + ECM = PCM) SEEN ON NEVER CARS.
ECU/ECM,, BINGO?
TCM transmission
ABS
HVAC BRAIN BOX
AND MORE, (SEE SERVICE MANUAL FOR ALL THAT)

crankshaft position sensor faulty...works until it gets hot then shuts down entire engine until it cools. replace the sensor.

what is the probable cause of error code U0019 hyundai starex 2002

more than sure,o2 senser+catl conv,nothing else.

P0320-is Ignition/Distributor engine speed input circuit. Inspect the wire harness and electrical plug ins in the area of the distributor. Replace the Ignition/Distributor engine speed sensor. This should clear up your Tachometer problem. Good Luck and happy new Year. From Ernie @ RedDeer, Alberta, Canada.

P0500 error code on Hyundai sta fe 2004 2.4 L where are the input and output speed sensors located?

plug it into a scan tools .it could be a camshaft sensor or crank sensor ,,scan tool can deside this

it is probably going into a fail safe mode, get it to a dealer and have it scanned for dtc's

For the 2004 Hyundai Santa Fe:
I do not know if you have the 2.4L DOHC In-Line 4-Cylinder, 2.7L DOHC V6, or the 3.5L DOHC V6 Engine; however the Link below has all three Diagrams.

Click on the following: direct, free Link. It has the Belt Diagrams for your 2004 Hyundai Santa Fe. It also has very helpful Instructions and Directional Diagrams.

Let me know if this helped...
http://www.2carpros.com/car_repair_information/year/2004/make/hyundai/model/santa_fe/2004_hyundai_santa_fe_drive_belt_routing_diagram.htm