How to repair left turn signal and brake light, changed bulb, No voltage in fuse box, fuse is ok

Note the diagram. Left rear turn, the light green wire with orange tracer is voltage. The black wire ground. You need both voltage and ground. Use a test light to check. The voltage for turn signal comes from multifunction switch. As far as the ground, you could try a redundant ground? good luck

First remove and test the brake and turn signal bulbs, if ok energise the brake and turn signal circuits, connect a voltmeter to the center of the bulb holder to shiny part of the metal body frame , should be battery voltage if ok the light frame has a bad earth,if no voltage a bad connection or broken wire going to the light.

Sounds like you've got two different problems, because the brake lights and turn signals are on different circuits.
1. Brake lights. These should work whether the engine is on or off. Check fuse box for a blown fuse. If OK, check for voltage at one of the lights with the brake pedal depressed. If no voltage, brake light switch under dash probably bad. Fairly easy replacement.
2. Flashers/turn signals. The flashers should work with the engine on or off. If they don't, might be a bad fuse. If that doesn't fix it, might be a problem with the wiring connected to the turn signal switch, or the switch itself.

First replace the turn signal light bulb. If that does not work check the voltage at the signal light bulb socket .there should be 12 volts there when youput on theleft turn signal. Normally thefuse for the signal should be for theleft and rightturn signal system. Sinceright turn signal is fune then it cannoy be the fuse.

disconnect turn signal switch wires @ column, put power to wires to brake lights. that cks wiring to lights. next put power to wires through turn signal to ck switch. Power runs from brake light switch to turnsignal switch, to lights.

Brakes are generally not fused seperately. Have u check the bulb in the left side.

Fast flashing dash signals mean there is a bulb issue-DEFINATELY!

Hi, your van does not use the signal filaments for the brake lights. You must have a wiring issue. Check for power at the brake light switch. If you have power there, the wire is broke from the switch to the S304 junction. If there is no power to the switch, the wire is broken between the fuse box and the switch. Please let me know if you have more questions, and thanks for using FixYa.

Replace the turn signal switch. All of these lights run threw it.

check fuse number 7 in Engine Compartment Fuse Box , if its ok you need change turn signal switch