Hello victoriaulre,
Below I will provide step by step instructions and diagrams.
1. Drain radiator.
2. Remove the air cleaner duct for access radiator hose.
3. Reposition the hose clamp( circled in red) and then remove the radiator hose from the thermostat housing.See image below.
4. Remove thermostat housing bolt/stud.
5. Remove the thermostat housing and gasket.
6. Remove he thermostat.
7. Clean the gasket surface on the thermostat housing and the engine block.
To install, reverse above procedure.
Torque the thermostat housing bolt/stud to 18 ft.lbs.
Fill radiator and check for leaks.
I hope this helps.
Regards,
Jerry
×