2005 chevy equinox making a roaring noise with vibration in front end changed brakes barrings what else could it be? The faster you go the louder the noise and vibration HELP

Did it do this before things were replaced? Did you replace the half shafts (driveshafts)?

the wheel bearing is OUT

axel barrings are bad had that problem before

check ball joints, tie rod ends, inner and outer. sway bar links and bushings. shock mounts (bearing plate). control arm bushings.

This is your radiator fan... it willl pull air through when it is needed to keep your engine and coolant cool... if your engine needs to cool quickly it will blow harder making the "roaring" sound louder

Have you looked at the Universal joint(s)? If it is 4-wd I'd inspect the front driveshafts as well - Other than that, I'd also inspect the brakes to ensure that the shoes were being held down properly and that the Universal joint is not worn - It sounds alot like either the U-joint or a brake problem - Have you inspected the rear end? Do you use the truck to pull anything? If you'll look at the U-joint and Brakes - If not, there are carrier bearings inside the rear end that may be the culprit as well, but I'd leave them for last as inspection is a bit involved -

I'd start by checking the brake pads and brake disks

i have a 2000 doge straus and i put two sensors in and it still wont shift any ideas out ther it was fine when parked a year ago so i know the tranaxle is good

if the noise isassociated with "wheel speed" then it is in the rolling parts... axle hub bearing brake rotor caliper wheel or tires...if it goes away on right turns then you are unloading or separating the issue then...so a hub /wheel bearing /axle issue is most likely...does your brake pedal pulse when you feel it..(riding the brake while driving)..does the steering wheel shimmy ?

You must replace wheel bearings in pairs to avoid loading the old bearing and, in time ruining your new bearing hub it is possible that you have already damaged the new hub