I have a problem to intal the lifters guide
Pull intake off pull off valve covers,loosin rocker arm bolts and remove ,, pull push rods out, after you have the push rods out you can pull the lifters out,,,,,,i suggest taking to a mechanic shop,,, if all you have is a ticking sound try this,,, buy a can of chemtol spray,,,chemtol only,,, with the little red straw for spraying,,,remove valve cover,,try to see if you can hear which lift or lifts is ticking,,,turn off car,,,loosen not remove that rocker arm,,,slid to the side,,count your turns,,,move rocker to the side,,, take chemtol spray and insert little spray straw and spray it down the hole in the center of the push rod ,, it will clean the lifter of the debris that is not letting it prime up,, repeat if nessary,, it works,,, see YOU TUBE,,, dirty oil causes this,,, put in clean oil and some lucas oil treatment to help prevent in future,,, keep oil changed ,,if it starts ticking again change oil and add more lucas,,, it might fix itself
Fig. Fig. 6: Remove the spark plug wire separators from the valve cover
Fig. Fig. 7: Compress the engine air cleaner-to-valve cover hose clamp with pliers, and slide the clamp back ...
Fig. Fig. 8: ... then disconnect the hose from the valve cover
Fig. Fig. 9: Unfasten the valve cover retainers and remove the valve cover-2.0L SOHC engine
If removing more than one valve lifter (tappet), mark the lifters and their locations as they must be installed in their original bores.
To install:
ADJUSTMENT
Although it is sometimes possible to reuse an old cylinder head cover gasket, in most cases it makes more sense to purchase a new one before beginning the procedure. Some vehicles may require the use of silicone sealant either with or without a new cover gasket. For more details, please refer to the cylinder head cover procedures in Engine & Engine Overhaul of this repair guide and refer to the gasket manufacturer's instructions.
Z24i Engine
See Figures 1, 2 and 3
For the intake valves: 1-4-5-8 valve clearance is 0.012 in. (0.30mm). For the exhaust valves: 2-3-6-7 valve clearance is 0.012 in. (0.30mm). The pivot locknut torque specification is 12-16 ft. lbs. (16-22 Nm).
Fig. Fig. 1: Check the valve clearance with a flat feeler gauge-Z24i engine
Fig. Fig. 2: Loosen the locknut and turn the adjusting screw to adjust the valve clearance-Z24i engine
Fig. Fig. 3: With the No. 1 piston at TDC, adjust the top set of valves FIRST; with the No. 4 piston at TDC, adjust the bottom set of valves SECOND-Z24i engine
Fig. Fig. 4: Cross-sectional view of an installed hydraulic valve lifter-4 cylinder engine
Fig. Fig. 5: Cross-sectional view of an installed hydraulic valve lifter-6 cylinder engine
172 views
Usually answered in minutes!
×