2003 Audi A6 Logo

Related Topics:

c
courtney peterkin Posted on Mar 23, 2015

Audi a6 trans sensor located - 2003 Audi A6

5 Related Answers

Anonymous

  • 141 Answers
  • Posted on Jan 23, 2009

SOURCE: thermostat audi a6

look under car on water pump housing, the thermostat is on a metal housing that looks like an igloo and has to bolts perhaps 10mm or 13mm, and an "O" ring in between

Ad

Anonymous

  • 47 Answers
  • Posted on Aug 02, 2009

SOURCE: Alarm oil sensor in my Audi A6 1,9 tdi -2000.

sounds like a faulty oil level sensor i,v replaced them in the past you need to get it checked first because the sensors aren,t cheap

Anonymous

  • 1874 Answers
  • Posted on Oct 13, 2010

SOURCE: WERE IS MY THERMOSTATE AND

1998 Audi A6 2.8 Quattro
1. Thermostat location:

ae944f7.jpg
2. Crankshaft Position (CKP) sensor location:

ac0a096.jpg

Anonymous

  • 1874 Answers
  • Posted on Mar 17, 2011

SOURCE: crank sensor crank sensor location

See the picture below:

tdisline_347.jpg

ZJLimited

ZJ Limited

  • 17989 Answers
  • Posted on Mar 29, 2012

SOURCE: why is my 2001 audi a6 is overheating 140,000 miles

Hi there:the Audi manual never talks about a 2 stage aux fan just that the aux fan runs with ac on and it can run with out ac on if there is an overheat issue on the coolant side where as the a4 info clearly states a 2 stage aux fan system that would lead me to think the early 4.2 did not use a 2 stage system. Your car is not overheating and boiling over out of the coolant tank it is showing a little hotter than what would be perfect but it is still in what Audi calls acceptable range. The whole coolant system is new I would start looking at your sensor and gage systems there is a coolant sensor in the rad but that is most likely new if they replaced the rad. The gage uses a temp sensor on the engine for the gage I would replace that sensor and test the gage with a resistance input tool we have at the dealer. Could be a gouge or the wiring to it. There is a coolant fan module that could be defective if your sure there was a two speeds to the aux fan.


3_29_2012_12_55_02_pm.jpg

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to add automatic transmission fluid to an 2001 Audi a6 Quattro 2.8

Transmission Fluid Filler location - AudiForums.com

www.audiforums.com > Home > Audi Models > Audi A6
Apr 20, 2017 - On the 2.8 you need to jack the vehicle up -keeping it level - run the motor until the trans is at a specified temp as indicated on VagCom - and fill the trans until the fluid drips out of the top hole. ATF filter (as on most cars) is located in the transmission oil pan. The filter is attached to the valve body. 2001 A4, 2.8L Quattro Automatic - Transmission: To Flush, or ...
Apr. 20, 2017
where is the transmission fluid and stick on 2000 a6 ...
Apr. 19, 2017
Transmission Fluid change on High mileage? - AudiForums.com
Feb. 18, 2009
2000 A6 Transmission Problems?? - AudiForums.com
Apr. 20, 2017
More results from www.audiforums.com
0helpful
1answer

Where is the IAT sensor located on a 2000 audi a6 2.8L

generally is located on air delivery pipe
0helpful
1answer

LOCATION OF B1S1 SENSOR FOR 2002 AUDI A6 QUATTRO

Referencing oxygen sensor or O2 sensor or 'lambda sensor':

B1S1 is 'bank 1', which is the passenger side cylinder bank on a V6 or V8.

S1 is the 'upper' or 'upstream' sensor, closest to the cylinder.
0helpful
1answer

How much doesit cost to install a sensor in an Audi A6 2001

More than a dollar and less than ten-thousand dollars. It depends on which sensor you are wanting to replace, where the sensor is located on the vehicle and who is doing the replacing.
5helpful
1answer

Getting OBD codes p0420 and p0430, how to fix these issue with my 2001 Audi A6

2001 Audi A6
EOBD code: P0420
Fault location: Catalytic converter system, bank 1 - efficiency below threshold
Probable cause: Catalytic converter, wiring, heated oxygen sensor 2 (downstream)

EOBD code: P0430
Fault location: Catalytic converter system, bank 2 - efficiency below threshold
Probable cause: Catalytic converter, wiring, heated oxygen sensor 2 (downstream)
0helpful
1answer

Audi shifter stuck

theres a small button located near the shifter.press it and you will be able to move the shifter
1helpful
1answer

I have a2002 2.5 audi a6 how do i check the automatic trans oil level, it is a turbo diesel with multitronic trans.

you cant check the Transmisson oil by yourself it is located under the vehicle. you will need a hoist to lift it up and then go by the transmission and check it there.
14helpful
4answers

200 AUDI QUATTRO A6 TRANSMISSION CHECK.

The trans don't have a dipstick, they have to be checked at a dealership with a vag tool, they have to be checked at a certian temperature of operation, as far as fluid i would use the audi recommended G-052-162-A2 atf fluid required
Not finding what you are looking for?

1,232 views

Ask a Question

Usually answered in minutes!

Top Audi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...