SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: how to change fuel filter on 2001 ford explorer
it in the tank so your gonna either gonna have to drain the tank and lower it to the ground,it shouldn't take more than 30 minutes.make sure you put the seal back in right,so it won't leak,it aint very hard.
SOURCE: where is the resistor in a 2001 ford explorer
You have to remove your glove box and it is behind there. Here is a picture of where it is. This particular picture is from a 4 X 4 so if you don't have that it won't have the 4X4 part. Let me know if you have any more questions. Thanks for using FixYa!
SOURCE: 2001 explorer SportTrac blower only
you need to replace the blower motor resister in the heater plenum case, 2 srews, 4 or 5 wire connector. If it blows again, you will have to replace blower motor as it is drawing too much current & failing the thermal fuse in the resistor pack.
sample
SOURCE: I have a 2001 sporttrac. No reverse lights. When
Have you checked the light bulbs already Have you replaced them Id they are the wrong watts it can draw to much power Make sure the wires are not grounded touching or disconnected if not Sounds like bad wiring somewhere down the line
236 views
Usually answered in minutes!
×