What is the proper air pressure for tires on a 2006 Suzuki Reno

is this a HVAC question heater and a/C?
cold engines, make only cold air
hot engines make hot air.
for 100 +years. now.

the cluster lamp, well that's easy,
turn key, all lights i dash glow as a test. see it TPMS
or open up glove box operators guide, see that page telling you same? and more.. on topic, lost it get one?

4 bucks a gander
https://suzukipitstopplus.com/Products/1067-2007-reno-owners-manual.aspx

same for FSM book (service), see it? see both?

TPMS #2 old post, and rare on this topic so will answer.
next post adds how to reset it,?
now that is a loaded question avoiding all systems,,,,,
YOU dont., it's Automatic for 4 bucks you can read the whole
full rules in the FSM.
https://suzukipitstopplus.com/Products/1068-2007-forenza-reno-service-manual.aspx

did you use a scan tool yet, most cars will tell you which tire is wrong. (are the all at spec pressure? ) including spare?

steps to take in all cases
1: tire pressure correct.
2: connect any scan too (can-bus) to dash DLC 16 pin connector
3: keyon and scan.
4: see DTC C0750 (or many others0 750 is.
Transmitter Battery Voltage is too low. tire #1

this is first, repairs are next. (actually more tests)
we have a hand scanner now cheap, to scan all tires.
(battery bad, pressure low, dead, or? other errors on sensor, even too hot)

could be two things. check tire pressure first. If okay and still pulling left, alignment is off. Need alignment

did you try googling this?
do that and get like zillion hits.
try this.
2006 Suzuki Reno new key fob.
here ill type that for you.
https://www.google.com/webhp#q=2006+Suzuki+Reno+new+key+fob.

no prob.,. there you go.

it will need service,
check pressures.
hot air as in heater on, so turn off the heater,
test in pure A/C mode Cold.
when both A/C and heat are on this is called defrost mode
which adds cold dry air to hot air and dehumidifes the hot air and window.

Hi. You'll need a 17mm socket and wrench. A screwdriver or something to remove the clip from the brake hose and a 15mm wrench to hold the back of the stabilizer link. The 17mm socket will be used to remove the top bolt and the stabilizer bolt and the 2 bolt and nuts holding the strut. Oh, remove the tire first. Hee.

Tire pressure warning light. Sound like you have a low tire

Go here for your owner's manual

http://pdfcast.org/pdf/2008-suzuki-reno-owner-8217-s-manual

good news is it can be changed with no tools in about 2 minutes. just take out the glove box and the cover comes off easy.