How many pins does the ECM have on the 2002 Kia RIO 1.5 CC

SOURCE: 2002 Kia Rio runs rough when idling

well spend some change and have a simple tune-up.  Plugs and filters and readjust the idle.

SOURCE: 2007 kia rio - owners manual missing

check this site

http://manualspace.com/kia-rio-rio5-2008-owner-s-manual.htm

SOURCE: resetting airbag on 2002 kia rio

Typical code readers (OBDII) won't touch the airbag lights. Neither will disconnecting the battery and waiting. If the airbag light is flashing, there's a code involved. The system may or may not work when needed. If it's on steady, the system is failed and will not deploy when needed. Typically, it's a connector in the various harnesses involved. Unfortunately, the Kia shop manuals just say "replace everything" so they're no help. The dealer has the very expensive code reader to read & reset the airbag light. In other words, $$$.

SOURCE: knock sensor replacement

Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

SOURCE: what is the proper spark plug gap setting for a 2002 Kia Rio

Hello mfriesner71; my name is Roger and I will answer for you. The correct plug gap is 0.027 to 0.031.in. Any gap between these will work fine. Just make sure they all gap the same. Should you need further help please just ask. Please rate the answer. This way I know it was helpful. Thank You for using Fix Ya. Roger