2000 bmw 323i auto trans wont go in reverse. i just had the front and rear brake pads and rotors changed. the ABS light is on as well even after the change.

the abs has nothing to do with brake pads. the abs runs on speed sensor on each tire. if your brake light is on all bmw have a wire in the brake pads for warning the brakes are low

keep bleeding and bleed the front as well the littlest amount of air will keep pedal spongy if the abs came on after doning brakes check the abs lines and connections up front the abs lines sometimes get banged up will doing brake job the abs sensor is the wire that runs from behind the rotor to the fire wall sometimes they get hit knocked into or damaged if wiring looks good have vehicle scanned for code .the code will make it easier to pinpoint what side-- if circuit problem--or if sensor went bad most auto stores offer scanning for free

sounds like an abs sensor has gone at the rear ,this can knock out the speedo as well

this problem is going to be your front rotors being warped. either have them machined or replaced.

Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

check your calipers one of them got locked up that is why the car wont move

Did you get the rotors machined to specs or just change the pads.If not machined suggest you get them checked to see wether they should have been.This affects ABS equipped vehicles more severely