SOURCE: How do you replace a windshield wiper motor on a Hyundai 2002
Remove the wiper arms and lower windscreen cover. Check the wiper motor linkages first .These clips normally come loose.Refit or replace the clip
SOURCE: oil change procedure on a 2005 Hyundai elantra
it is very easy to change the oil put the car on ramps secure the back end look for the drain plug underneath the engine make sure you have the right size wrench and when you remove the plug also check the gasket on the plug to make sure it is not cracked you will also need an oil filter wrench and my other suggestion to you is to go to autozone to see if they have a Haynes repair manual for your car and if they don't see if they can order you one in the mean time they can also print you off a diagram of how to change the oil in you car safely
SOURCE: need fil for error code P2626 Hyundai Elantra GLS
P2626 O2 Sensor Pumping Current Trim Circuit/Open (Bank 1 Sensor 1)
I'll sure this has to do with a faulty O2 sensor. This sensor is usually
located around the header of your car, or down more on your exhaust.
Try disconnecting your battery for 30 mins, hook it back up, and start
your car again. This will erase the error. See if it comes in again.
Hope this help (remember rated this post).
SOURCE: how to replace 2002 hyundai elantra hub and bearing
With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.
82 views
Usually answered in minutes!
×