Airbag light was permanently on so checked and cleaned connectors under drivers seat now if goes off but lights up now and again do I need to get anything reset or cleaned ?
SOURCE: driver's airbag light on 2007 PT Cruiser convertable
The first code is for "driver seat track position sensor low". The module detects that the sensor input is less than or equal to 0.3 mA. The second code is referring to the first code. I have no idea what the third code is. Basically you have two different communication systems mixed. The 2001 uses the PCI bus system and the 2007 uses the CAN bus which is much faster. The first code is a CAN bus code and the second is a PCI code. As far as the airbag deploying in the event of a collision, I don't believe it will with an active code in the system. I hope this helps.
SOURCE: Both my front windows do
the air bag system runs constant diagnostic checks.It then will display a code one flash two flash and so on.Most common is the battery backup code.Check fuses under the hood for air bag.For your power windows check fuses under hood.Then check your window relay to see if its working.Swap it out for a similar one.Check fuses inside vehicle also.check wire connection for power windows.
Testimonial: "Thank you so much. "
SOURCE: how do I check airbag connector under seat the airbag light is on and it failed mot because of it ?
Airbag system failures are difficult to identify and correct unless you have a scanner that can read the codes from both the primary airbag system and the Passenger Presence Module. Since the voltages and currents are low, it is common for corrosion in connectors to cause the system to fail. So get or borrow a scanner which will tell you exactly what is wrong and if it is an open circuit, remove the seat from the floorboard and tilt it back a bit to better access the connectors and clean the pins and sockets with alcohol and a swab. Test the source connections for the proper resistance to ground and voltages using the service manual as a reference. Continue to use the scanner to see if the problem clears up by clearing the code and checking to see if it returns. If the source connector pins are good and cleaning didn't solve the problem, grease them with a conductive grease.
820 views
Usually answered in minutes!
×