2007 Chevrolet Chevrolet Cobalt LS Logo
A
Anonymous Posted on Mar 01, 2015

2007 cobalt horn relay location

No horn

1 Answer

Jeff Armer

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Chevrolet Master 15,575 Answers
  • Posted on Mar 02, 2015
Jeff Armer
Chevrolet Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Nov 22, 2012
Answers
15575
Questions
1
Helped
7110360
Points
73899

The relay is located in the under hood fuse / relay box . Marked HORN PCB relay , If you change it out an horn still doesn't work ,you can test to see what is missing right at the relay . Two of the pins at the relay socket should have battery + , one should be open an the other should show ground 0 ohm's . If you look on the side of the relay there is a diagram of the pins. 30, is Battery +, 87 goes to the horn . When you push the horn button on the steering wheel it causes the relay coil to energize closing the contacts in the relay sending power from pin 30 to pin 87 down to the horn turning it on ! Pins 85 an 86 are the control side , one should have battery + an other should be open , till someone pushes the horn button . You can test for power with volt meter an test with ohm meter for ground on the one , an a open on the other one, an have someone push the horn button an it should change to 0 ohm's .

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Where or how will I locate the horn relay on a 2007 1600 Ford bantam horn relay

Number Description 1 Ignition relay 2 Windshield wiper relay 3 Horn relay 4 A/C switch relay 5 Not used 6 WOT relay (petrol) 7 Power hold relay 8 Fuel pump relay (petrol) 9 Low beam relay 10 High beam relay
ford-bantam-fuse-box-central-junction-top-view-relays-undefined-undefined-0.jpg
0helpful
2answers

2007 Nissan Maxima horn won't work

Have you checked the fuse? It will be in the fuse box near the battery. It will be marked on the guide on the lid as a trumpet.
1helpful
1answer

Where is the horn relay located on a 2007 ford edge sel

It is located in the SJB - smart junction box an it is a non- serviceable part . soldered to the board inside . Where do you hear the clicking noise coming from ? The SJB is located behind the left side kick panel .
SECTION 413-06: Horn 2007 Edge/MKX Workshop Manual DESCRIPTION AND OPERATION Procedure revision date: 10/30/2006 Horn The horn system consists of the following components:
  • Horn switches (part of the steering wheel)
  • Clockspring
  • Horn relay (part of the smart junction box [SJB])
  • Horn
For removal and installation of the steering wheel, refer to Section 211-04 .
For removal and installation of the SJB, refer to Section 419-10 .
Principles of Operation
The smart junction box (SJB) supplies the control and switched voltage to the horn relay (part of the SJB). When the horn switches (part of the steering wheel) are pressed, ground is supplied through the clockspring to the horn relay. The horn relay is then energized directing voltage to the horn and enabling the horn to sound. When the vehicle security system is armed, the SJB provides a momentary ground to the horn relay control side to indicate the system is armed, and an on and off ground when an intrusion is detected or the panic alarm is activated.
If your horns are not working ,you have a wiring problem or the clock spring is open . If the relay is bad the whole SJB has to be replace an the dealer would have to do that . Needs to be programmed ,with factory tool .
Symptom Chart Condition Possible Sources Action
  • The horn is inoperative
  • Fuse
  • Circuitry
  • Horn
  • Clockspring
  • Steering wheel switch harness
  • Horn switches (part of the steering wheel)
  • Smart junction box (SJB)
  • Go To Pinpoint Test A .

You
0helpful
1answer

Horn relay

no horn relay, but the connector wire for the horn can be a problem, check that ti has not go green connection inside the plug wire if has be careful and clean it out also check the earth wire under the batter plate.
3helpful
1answer

Horns where is horn relay 2007 honda civic

If you need help diagnosing your horn circuits, please vitit my profile or click one of my ads and sign up for email support. By doing this I can provide instructions, wiring diagrams and component location diagrams.

With all that said, the horn relay in your 2007 Honda Civic is located in the under-dash fuse/relay box (left end of dash)
1helpful
1answer

I have a 2008 chevy cobalt 4dr. I`m just wondering if someone can help where is the location of the horn. Mine is not working. I can hear the clicking of the relay when i press the steering wheel but not...

The horn(s) are buried behind grill. You have to disassemble grill and a ton of hardware by AC condenser and fans. Horns are mounted on front side of radiator support.
5helpful
1answer

How to replace horn relay on 2007 jeep wrangler

b626af4.gif
The horn relay is located in the Intergrated Power dist Box, This is a Cherokee, but you get the idea.
Not finding what you are looking for?

2,766 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...