My 2005 Jeep Grand Cherokee's (5.7L) windshield washer is not working on both the front and back. I cannot hear the motor working either. The first thing I would check is the fuse, but I cannot locate which fuse it is in the manual either. both windshield wipers work and everything else is fine except for the washer component. Any idea which fuse controls the washer? If it's not the fuse, what should I check next?
Check power at the pump motors. You may not see a fuse because some run off a circuit breaker. If all else fails, a bit "backyard" but you likely could break out the washer pumps from the system and make a simple push button on the dash to operate them.
SOURCE: 1995 jeep grand Cherokee windshield wipers will
your problem is the wiper motor its self,the park position in internal,you will need to replace the motor
SOURCE: how to change the windshield wipers on a 2005 jeep
Press in on the clip on the wiper blade and pull down. To install put the wiper around the hook and pull up until you hear a click and it locks in.
Check out this youtube video for more help. http://www.youtube.com/watch?v=cJN7NqkUd1k
SOURCE: 1995 jeep grand Cherokee windshield wipers
the motor is bad has to be replaced the wiper delay is part of the motor .
SOURCE: what fuse # for front wipers for 1996 jeep grand cherokee.
hi there;
if you can find you fuse box just pull the cover off and look on the inside of the cover it will show you what fuse the amprage and the location in the fuse panel they are numbered ok
Junction block location-1999-04 Grand Cherokee
Inside your Jeep.
3,423 views
Usually answered in minutes!
×