Why doesn't the Windshield washer work on my 2014 Dodge Ram 2500? The wipers work fine on all settings

SOURCE: 98 camry windshield wiper

You will have to change the swich that control the wiper blades cause sometimes they go bad

SOURCE: Windshield wipers don't work but the motor runs . 93 Dodge Dakota

remove wiper arms and then you can raise the hood to remove screws that hold down the vent panel.
now carefully remove vent panel.

SOURCE: Where is the windshield wiper

under plastic cover on cowl

SOURCE: my front windshield wiper pump

First make sure you have water in washer reservoir, with ignition on reds (not started) then get someone to operate washer while bonnet is closed otherwise the wipers (may come on) may damage your bonnet (would also be a good idea to throw some water on your screen before commencing), listen for a buzzing noise, if you can hear that noise than your washer motor is ok, if not - if fitted with fuse check it and if fuse is ok than your motor needs attention. If motor is ok than while someone is operating the washer motor look under the car to see if there is any water leaking, if there is water leaking than the hose going from your washer bottle to your washer nozzles has come off somewhere, visually check this hose, usually small diameter and clear in colour, reconnect or replace it. If there is no water leak and you have full water and motor is working, than your nozzle, usually located on the bonnet or wiper arms are blocked, this mainly happens after polishing the vehicle. There are 2 main ways of cleaning these nozzles, easiest way is to get a fine pin and poke it several times, this will clean it 85% of the time, if it does not work than you need to find the hose that connects to it and pull apart at a join, closer to the nozzle the better, and give it short burst of compressed air, have to be careful not to pop the hose out at the nozzle as some of them are located in really awkard points, hope this helps.

SOURCE: what fuse works the windshield washer pump on a 2006 mustang

No they use the same fuse. The pump motors do go out. they are easy to change

Testimonial: "Dennis, thanks for the quick response. I went through the owners manual and couldn't find one for just the washer pump and figured they were the same. You saved me from having to break that stupid fuse box cover open. Waiting for the weather to warm this weekend and will swap out the pump. "