Re: Trouble shoot 2500masda truck that won t start after...
Did you reconnect the wires and re-position the clutch safety switch at the clutch pedal assembly? If this switch is not positioned or connected correctly it will not allow the truck to start.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Good after noon, it`s definitely inside the gearbox, but you might be lucky to get the gear lever out by removing the gear lever it selve then try pulling the 3rd sellector in place, normally when that happence, the bushes on the gear lever ball is worn out and has to be replace, hope my info helps. regards
on a manual transmission the Clutch Slave Cylinder is located on the drivers side front of the transmission. You can locate it by first finding the clutch master cylinder on the drivers side of the firewall. Then fallow the plastic line to the front of the transmission.
To remove the slave you will first twist it then pull it out of the transmission.
The clutch slave and mater cylinder are replaced as an assembly.
The solution is pretty cut-and-dry. Fix the fluid leak and your transmission will go into gear. I don't know what to tell you to fix exactly because I do not know where it is leaking from. If it is leaking from the slave cylinder, replace the slave cylinder; If it is leaking from the master cylinder, replace the master cylinder, etc.
Fixing just one part of the clutch may not be the best option for you however. Clutch parts seem to wear out all within a few thousand miles of one-another. Depending on how many miles are on your vehicle you may want to do a complete clutch replacement so you won't have any further clutch problems for several years.
Check your clutch fluid in the resovoir if it is low,you may have a bad clutch master or slave cylinder.If ther is plenty of fluid your clutch may be worn.You need to replace the clutch master and slave cylinders together as a pair.
×