Google it; there are a ton of diagrams available...
Diagram of coolant reservoir on 1996 mazda 626 Google Search
SOURCE: Mazda MPV Coolant Loss (but no overheat)
i had the same thing on my wifes 2000 mpv van...the ends of the radiator are made of some sort of composite type material....it had a slight crack in it....wasn't obvious until it got worse and started streaming water from it when warmed up....even after it cooled enough not to be spewing it was hard to actually see the crack though a few inches long....was hard to even see where the water and antifreeze mixture was coming from until i took out the radiator
SOURCE: mazda 626 ( 1997, 2.0 petrol ) alternator belt diagram
Dumb question, but, did you happen to the diagram on the underside of the hood, the strut tower towards sides of the motor or on the radiator support.
SOURCE: cost to replace waterpump on mazda 626 1996
Go to (repairpal.com) and enter all your info & pick repairs for pricing in your area.
SOURCE: transmission in 1996 mazda 626 slow to shift high rpm
if its reving high then shifting then your trannys going
SOURCE: coolant fan on my 1998 mazda 626 is not working
Unplug the plug that lives on the side of your radiator and take a small wire and jumper the two wires in this two conductor plug. If the coolant fan turns on, you probably have a bad thermo switch (the thing the plug was plugged into on the radiator) and needs to be replaced. I assume you've idled the car until it starts to boil, noticing that the fan never comes on. If this is the case, that is your solution. Good luck.
251 views
Usually answered in minutes!
×