My 2008 Ford Focus won't start no fuel delivery to filter is this the fuel pump if so where is it located on the car?

The crash sensors should be mounted off the front horn of the frame ( on either side). The sensors will be leads and wires that go back to the "black box" located under the body towards the front firewall. This is where the information us processed and sent to the airbag deployment system and allows for for fuel delivery shutoff.

the fuel filter is not in the tank,the fuel pump might be thats why you need the haynes repair manual to see where these items are located,fuel filters are usualy outside the tank on the fuel line and the fuel pump might be able to be accessed under your back seat or trunk,but you would need the manual to know for sure or look it up on a search engine

crank sensor located off the fly wheel in transmisson

Check on your inline fuel filter. If this clogged the fuel pump cannot pump gas through it to get to motor.

I would replace the fuel filter first then go from there .. Could be a few things causing bad fuel delivery

Hi, it's back by the fuel tank.

NOTE: The fuel filter is located underneath the vehicle in the area of the rear suspension.

1. Relieve the fuel system pressure by removing the fuel pump fuse from the battery junction box, starting the engine, and allowing the engine to idle until it stalls.
2. Raise the vehicle.
   NOTE To remove the lines, press the quick-release tabs on the connectors.
3. Remove or disconnect the following:
   
   Evaporative Emissions (EVAP) vapor line Fuel filter lines Fuel filter and bracket assembly Fuel filter
5. 
6. Fig. Location of fuel filter and lines.

To install:

1. Install or connect the following:
   
   Fuel filter Fuel filter and bracket assembly Fuel filter lines EVAP vapor line
   
2. Start the engine and check for leaks.

If you are thinking in a replacement, remember the position the fuel filter into the bracket. Ensure the fuel flow direction is properly aligned:

1. Install and tighten the fuel pump bracket bolt.
2. Lubricate the fuel tube fittings with clean engine oil. Align the fuel tube fittings and press together until a click is heard and then pull on the fittings to make sure they are fully engaged.
3. Start the engine and check for leaks.

Fig. Location of fuel filter and lines.

Hope help (remember rated and comment this).

have you checked that all the air is out of system after changing filter check to see if it has a bleed valve

the fuel filter on the petrol model is located at the front right hand corner of the fuel tank just forward of the right hand rear jacking point and need to be renewed regularly

the fuel filter on the petrol model is located at the front right hand corner of the fuel tank just forward of the right hand rear jacking point and need to be renewed regularly