1. Fill the cooling system
2.slowly add a mixture of 50/50 DEXCOOL and clean and drinkable water.Approximate fluid capacities from 8.2 L. to
9.6 L. depending of the size of engine.
IMPORTANT:it is necessary to maintain the coolant level at the top of the surge tank label to insure all the air has been purged from cooling system.
3.install surge tank cap.
4.start the engine.
5.run the engine at 2,000-2,500 RPM until engine reaches normal operating temperature.
6 allow the engine to idle for 3 minutes.
7 shut the engine off.
8 allow the engine to cool.
9 top off the coolant as necessary.
10 inspect for leaks, inspect the concentration of the coolant.
What size motor?
Please see my tip at http://www.fixya.com/cars/r5929960-s_thermostat . These are generic instructions. Specific instructions from autozone.com for your car are pasted below. If you get stuck, please get back to me.
Fig. Remove the thermostat
To install:
Fig. Install the thermostat housing to water pump feed pipe
421 views
Usually answered in minutes!
×