Question about 2004 BMW 5 Series

Open Question

When fitting new springs to my bmw e60 530i 2004 how do I remove the rear seats or do I have to remove them?

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 837 Answers

SOURCE: How do you remove the rear seat back on a BMW 318d

6353dd9.jpg

Diagram above

Posted on Mar 23, 2009

Ad

jhatsis

  • 67 Answers

SOURCE: how do access the battery on a 1994 bmw 530i?

Remove the two plastic covers around the seat belts then pull straight up on the front of the seat (it may take a sharp tug)

Posted on Jan 10, 2011

david winnemore

  • 34 Answers

SOURCE: remove rear seat 1994 525i

If you are looking to just remove the rear seat bottom all you have to do is pull up on the front edge

Posted on Feb 07, 2011

alicantecoli

Colin Stickland

  • 22485 Answers

SOURCE: 2004 series 3 BMW 316i

you shouldnt need to remove the rear valance to fit a towbar ,i would suggest you contact a authorised towbar fitting workshop as it is not permitted to fit a towbar yourself ,it has to be done by a company with the correct authorised dealership as the towbar has to be certified with a europeon certificate of homoglonation and a plaque .then vehicle has to be presented at the vehicle inspection station for conformity .Then the paperwork of the vehicle changed to show its fitted with a towing hitch and a fee paid for this service .alicantecoli_18.jpgalso the electrics have to be connected by a auto electrician as every annual vehicle inspection the electrics are tested as well where a towbar is fitted .

Posted on May 29, 2011

Testimonial: "THANKS FOR INFO DID'NT KNOW IT WAS THAT INVOLVED. WILL SEE HOW MUCH GARAGE CHARGE."

Bill Boyd

  • 53768 Answers

SOURCE: Remove rear door handle from a 2004 525i bmw

remove the door lining and you will see nuts up on the handle on the inside

Posted on Dec 25, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the lower rear seat


Hi there on a 3 series there are two heavy duty clips that hold the seat down and they are located along the front edge of the seat right in the centre of where the left and right rear passengers would sit, on these two locations grab under the seat and pull upwards fairly hard and the front of the seat will pop up, once the front is up then scoop the seat out. hope this helps

Feb 27, 2015 | 2004 BMW 3 Series

1 Answer

How do i replace the fuel pump in my 2004 525i BMW



I believe you gain access to it by removing the rear seat then a cover plate in the flooring. Hope this helps.

Nov 30, 2014 | 2004 BMW 525i Touring

1 Answer

Who do I remove rear seat for a BMW 760li?


Most rear seats need to be unlatched from the very bottom on each side. Try sliding the driver and passenger seats fully forward. With your back against the front seat press forward toward the trunk on the bottom of the rear seat on one corner at a time near the floor and lift up. This should release the latch. To replace the seat simply slide the seat back into place with the front slightly raised upward and push the seat in toward the trunk then push down til you hear the latch catch.

Nov 15, 2014 | 2004 BMW 760Li

1 Answer

I have just fitted two new real coil springs to my Ford escort mk4 cabriolet but now the rear left is sitting nearly an inch higher than the rear right what could be causing this ??? thanks .


The coils of the springs have to be positioned so that the end of the coil is in a depression in the seat . check that the spring that is sitting high is fitted the right way up and that the end is in the seat correctly. Normally coil springs have one end ground off so that it is flat while the other end just has the steel cut off. This is the end that has to be positioned correctly. Make sure that the rubber cushion pad is fitted correctly for the flat end.

Jun 08, 2014 | Cars & Trucks

1 Answer

Remove rear seat


To remove the bottom, just pull upward on the seat in the middle. Do you have the fold down rear seat or the fixed one. The fixed one has bolts near the top on the sides and at the lower edge slightly inward on both sides

Apr 14, 2014 | 2004 BMW 320i

1 Answer

How do you take the back seats out of a bmw 320i se to fit seat covers


To remove the rear seats, force your hands under the front of the seat bottoms and lift with a quick, short tug. The bottom cushion lifts out with no tools. There will be a couple of bolts holding the seat backs in place.

Oct 06, 2009 | 2004 BMW 3 Series

1 Answer

Are there any special tools needed to change brakes and rotors on a 2004 bmw x3


Front or rear. Front just sockets and mabey Allan wrench set. Back set, a spring removal tool and sockets. Metric

Sep 11, 2009 | 2004 BMW 3 Series

1 Answer

FUEL PUMP


Hello!

The fuel pump on a 3 series BMW is located under the rear seat.
To access it you will need to remove the lower part of the rear seat by pulling it up.
Then an oval shaped cover on the passengers side should become visible.
Under this cover is the fuel pump.
I would suggest taking the cover off and inspecting for signs of replaced parts.
(new parts should be shiny ;)

Hope this helps!

Sep 28, 2008 | 1999 BMW 328 Series

1 Answer

Replacing boot struts


Hi GB52. Just done this myself, should take 15 minutes perside max. 1/ remove rear seat cushion by bumping the centre back and up, lower the back rests down. 2/ Unscrew the striker plate from the seat side bolster and the bolt at the lower edge of the bolster Removing the bolster takes a bit of fiddling. 3/ use a flat-head screwdriver to release the strut spring clips - use the new ones as a guide. 4/ remove the old strut and fit the new one. reinstall the bolster, bolt and strike plate. note; when replacing the rear seat cushion, ensure the seat belts are fed through first and check that the seat retaining clips properly engage the floor panel brackets.

Hope this helps,

Davo

Jul 31, 2008 | 1983 Ford Fairmont

1 Answer

FIT SEAT BELT


TO GET AT REPEATER LAMP ON O/S MIRROR ON A GOLF TDI SE 2004 REMOVE THE TOP COWLING AND THE GLASS NEXT TWO SCREWS AT THE BOTTOM TO REMOVE THE LAMP NO BULB BUT FIT NEW LAMP

Jun 20, 2008 | 2004 Volkswagen Golf

Not finding what you are looking for?
2004 BMW 5 Series Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

auntyjack

Level 2 Expert

104 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1176 Answers

Frankie B

Level 2 Expert

70 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...