Where is 1993 Cadillac body control module located

The module must be programmed when a new one is installed, so if you attempt to replace it the vehicle will need to be towed to the dealer for programming. My point is you need the dealer to do this repair.

BODY CONTROL MODULE AND PCM ARE THE MAJOR COMPONENTS OF SELF DIAGNOSTIC SYSTEM. BCM CONTROLS MULTITUDE OF VECHICLE FUNCTIONS THROUGH MONITORED SENSORS AND SWITCH INPUTS AND ALSO PROVIDES SELF DIAGNOSTIC CAPABILITIES.PCM PROVIDES CONTROL AND SELF DIAGNOSTIC CAPABILITIES IN RELATION TO VARIOUS ENGINE AND EMISSION RELATED COMPONENTS IT MONITORS.**** BODY CONTROL MODULE IS PART OF PCM THEY ARE COMBINED AS ONE OR BOTH IN ONE.

Hello: Remove the glove box. it sets on top of the heater case. A box about 8" long, 2" thick and 6" wide with 3 electrical connectors.

REMOVE GLOVE BOX,BCM IS MOUNTED ON TOP OF THE HVAC CASE

BODY CONTROL BEHIND GLOVE ON TOP OF HVAC CASE THE ENGINE CONTROL MODULE IS ON THE PASS SIDE UN THE END OF THE HVAC CASE CLOSE TO THE HVAC PROGRAMMER

The pcm is located on the passengers side behind the glove box.There will be 2 computers one is the bcm and the other is the pcm.The bcm is the body control module.You will have to remove the glove box to remove the pcm.Get the part number and call the parts department at the dealership and ask them which one is which.I believe it is on the kick panel.Hope this helps.Good luck.

The anti theft module is actually the body control module.It is located in the back of the rear seat back.You can access the module through the trunk.Just remove the cover that is behind the back of the rear seat and you will see all the modules. The body control module is on the right.You will see a cross brace that goes across the back of the seat back.the bcm is about the middle of the right top part of the brace.Hope this is helpful.Good luck.

car-part.com , this site lists all the j-yards in your area

replace blower control module

In the trunk