Find fix my blinkers and flashers

Suspect the multi-function switch. (turnsignal) these fail a lot.

There is more than one flasher. One is for hazards and the other flasher is for directional signals. They are located under dash just left and right of the steering column. Don't go tearing up the steering column, then you are asking for trouble. Try the least expensive and labor intensive fix first.

There is only a few things that can cause blinkers to blink continually, meaning if your saying they wont shut off, Normally it is the blinker flasher or a fuse. Sometimes it can be in the blinker switch itself. I first would check the flasher, and turn signl fuse. If the blinker stays on and does not flash, still can be bad flasher or fuse or a ground problem, You would then have to check the wires around area where there contact to the tail light blinkers and front blinkers. But first start as said earlier with checking flasher fuse, switch and fuse. Mike

on the brake lights, check to be sure the switch located at the top of the brake pedal isn't stuck, you can Jumper the switch to see if that works,

The do not run off the same fuse but they do run off the same blinker. Try turning on the key, click the left/right (check both) turn signal and then operate the 4 ways on and off at the same time. Work the 4 way switch back and forth 10 to 25 times and see if you get any short winks or blinks from the system.
Turn signals are usually on their own fuse in the glove box and hazard are on with the brake fuse. If this does not work, I would look at the blinker. It is possibly bad. Check each pin of the blinker and see if there is power there when you turn on the 4 ways or turn signals. Replace Blinker. Make calls to parts stores and dealer for location of this blinker.

No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below:
Troubleshooting Procedure
To start troubleshooting this problem:

• Turn the key to the on position (do not start engine)
  
• Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
  
• When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
• 
  

There is 2 different flashers. One flasher for the turn signals and one flasher for the hazards. If you turn on the turn signals and the turn indicator on the dash lights up but doesn't blink, then most likely it is the turn signal flasher that is bad. Good luck.

RIGHT BLINKER dead ,front,back, or both..???? If front works, and rear doesn"t (REPLACE REAR BULB).....and vice a versa....If rear and front both don't work replace the FLASHER ..Flasher is located in the FUSE block area.......Listen to the operation of the LEFT or RIGHT flasher operation and you should notice a dirrerence....

flasher located at bottom of fuse box its round bout the size of a pop bottle lid,hazard flasher located at top

The turn signals don't work, but the emergency flashers do? If that's the case, replace the flasher, you have 2 flashers, one for emergency (hazard) flasher, and one for the turn signals. It should be on the fuse block under the dash.