How do I remove radio from 1999 Buick Le sabre

SOURCE: procedure to repaloce rear shocks

Removal & Installation

1. Remove the tire and wheel assembly.
   
2. Support the control arm with a jack stand.
   
3. Remove or disconnect the following:
   
4. Electronic Ride Control (ELC) air tube from the shock
   
5. Two bolts securing the shock to the control arm
   
6. Trunk trim to gain access to the shock upper mounting nuts.
   
7. Cover, the two nuts, and the reinforcement from the top of the shock
   
8. Shock from the vehicle
   

SOURCE: Where is the egr valve in a buick le sabre

The EGR Valve on this 3.8 L engine should be in front of the throttle body on the drivers side of the engine just to the right of the front valve cover. If you locate where the intake tube/duct attaches to the throttle body and then move just a few inches toward the front of the car it should sit right in that spot. It will have two bolts attaching it to the intake/tube. Hope you find it!!

SOURCE: HOW MUCH SHOULD IT COST TO REPLACE A FUEL PUMP IN

its just a gestament based on my experience with the cost of submersible electric tank pumps costing around $150 so allow around 200bucks for pump & labour although some pumps are over $300
Cheers rob.

SOURCE: 93 buick le sabre transmission slipping

i have a 94 and the same problem i added some lucasd transmission stopleak and it worked for a time but I know i need to have it checked by a shop

SOURCE: Buick Le Sabre 1999....the ''Air Bag Readiness Light'' stays on.

well really the only wsay you can figure out why the air bag light is on,is to go to the dealer so they can hook up the scanner and see what code it has in it,there could be a bunch of different things wrong with but the code will point you in the right direction,,,,,,but only the dealer scanner will read air bag codes,the cheaper scanners like auto zones actron,and even the cheaper snap-on and mac do not read it either,so your kinda stuck going to the dealer to find out, if your not familiar with air bags let them work on it,as you could accidently deploy the air bags when your working with the system,,they are sensitive and i would not want to see you get injured