Its 105 inch pounds. Tighten the bolts in several steps. when done, check for oil leakage. But.....At this point, its a 2004. You dont need a torque wrench. Its pretty easy to feel it. Obviously dont grind em in after they get tight but once theyre hand tight, go in your order, (middle to out if thats what you like) and tighten them a little further each time. Get it to where if you put anymore pressure its going to go too deep. You can do it without a torque wrench on these. You'll know, but again, just dont go crazy. I never use torque wrenches anymore except for head bolts or something that important. I've been a mechanic for lot of years. Kind of grew up with cars though. I never have ANY issues with any bolts or anything not torqued enough or over tightened. (I have went too far into aluminum on a saab one time but that was one water pump bolt, did the rest a little lighter and it never leaked) But last time, I am positive you can do these valve cover bolts, on a 2.7 at that, without any torque wrench whatsoever. I didn't think anybody used them on valve covers anymore unless the car is like, new or something. You will be fine. But, If you're not comfortable, I get it. Go ahead and break out the small torque wrench and do em at 105 inch pounds. Can you even get a torque wrench on the back set of bolts on that back one? Anyway, good luck and I'm willing to bet that you tighten them a little further than 105 when you see how loose 105 is, maybe not. But, you might not be comfortable with only 105"lbs. Good luck, and you got this!
1,273 views
Usually answered in minutes!
×