SOURCE: 2002 hyundai accent codes p1529 and p0734
P1529 means nothing more than the TCM (transmission control module) has
requested that the ECM (engine control module) turn on the check engine
lamp.
P0734 basically indicates that your transmission is slipping.
You need to take this car to an authorized repair center for hyundai cars. Replacing the filter and fluid on the transmission might save this transmission but I would be willing to bet that a total transmission rebuild is in order.
Good Luck
SOURCE: trans drops into 3rd gear won,t shift to 4th
DTC P0734 is "4th gear incorrect ratio" - that's your torque converter 'LOCK UP Clutch" It's worn out (or you're using the wrong Trans Fluid required by Hyundai - SPIII OR Both). The P1624 is simply the Trans Control Unit (computer) communicating to the Engine Control Module (ECM computer) MIL - on request signal to ECM = asking it to turn on "Check Engine" light. MIL = Malfunction Indicator Lamp. When the torque converter 'lock up" clutch slips or doesn't engage, the trans automatically returns to 3rd gear and stays there (it's called 'fail safe' mode) until you cycle the ignition key, then everything resets until the malfunction occurs again.
You'll need to have an AT (Automatic Transaxel) tester hooked up to verify this. Hyundai has a Service Bulletin specifically for "gear incorrect ratio' codes. If when you changed the trans fluid, was it done at a Hyundai Service Center? If not, someone may have installed the wrong fluid.
SOURCE: vehicle wont change up into gear reverse gear not
P0734 - 4th gear incorrect ratio. P1529 Malfunction Indicator Lamp Request. Problem is in the transmission.
Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.
SOURCE: 2002 Hyundai Accent 1.6 Check engine code
Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.
SOURCE: 2002 hyundai accent.transmission works great
Hi
Well two of the tranny codes ; P0734 and PO732 indicate gear 2,3,4 ratio incorrect. This can be caused by poor readings at the input and output speed sensors or pulse generators. The P1709 code is in reference to the kickdown servo switch.
Replacing the pulse generator set and TCM reprogramming( as per TSB) may solve your problem, otherwise you have a major component failure in the transmission unit. I would get some line pressures at the transmission checked first.
Sounds like the transmission is in fail safe mode, this happens when there is a transmission fault, you only have two gears 2nd and reverse.
Hope this helps - Steve
123 views
Usually answered in minutes!
×