Drain the rad into a pail.
remove the upper rad hose from the thermostat housing.
remove the thermostat housing
remove the gasket/seal (from housing or engine)
remove thermostat
install ne stat & gasket/seal
reinstall housing and hose.
close off rad bottom valve
refill rad with new coolant (with cap off run engine until warm
top up fluid to neck) replace cap.
dispose of old fluid at environmental recycle center
SOURCE: thermostat in 2001 dodge ram 1500
the thermostat is located where the upper radator hose comes off the engine there are two bolts or nuts remove hose and remove housing you will see the thermostat when you do clean old gasket material off block and reverse removal procedure
SOURCE: Changing front ball joints on Dodge 2500 2005
can it not be done without removing the hub ?? dont think you can get hub off without removing the track control ball joint?do you have the right tools??
SOURCE: 2006 Dodge Ram 2500 diesel truck----need inside fuse box diagram
If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.
SOURCE: 2006 dodge ram 2500 a/c fuse rely
The AC relay is located in the under hood fuse box. The cover should have a legend for location. Its one of the bigger black ones. You can rotate it with the horn or ABS one to see if its the problem. You may have a small fuse also in that box for it. If this doesn't solve the problem then you either have a leak or a computer problem. What a shop will do is try with a bidirectional data scanner turn the AC on. If they can't get it to turn on with a scanner then you most likely have a failed PCM if they verified you do not have low pressure or a relay or wiring or switch issue.
517 views
Usually answered in minutes!
×