04 chevy avalanche starts and dies also poer windows and door locks and keyless entry dont work all happened overnight

Remote Control Door Lock Receiver (RCDLR)
The remote control door lock receiver (RCDLR) is a multifunction module that operates both the keyless entry system as well as the tire pressure monitoring (TPM) system. When an RF message is received from a keyless entry transmitter, the RCDLR interprets this signal and will request via serial data that the body control module (BCM) perform the specific function, i.e. door lock, door unlock, or vehicle locate. The RCDLR also sends messages out to the 2 Way Advanced Remote Start transmitter.

Remote Control Door Lock Receiver (RCDLR) (AP3 or AP8, without E52)
Top rear of the passenger compartment above the rear window


Remote Control Door Lock Receiver (RCDLR) (AP3 or AP8, with E52)
Left rear of the vehicle behind the D-pillar trim panel

Body Control Module (BCM)
On the lower left side of the I/P to the left of the steering column


Good luck !

You probably have defective lock solenoids in the doors. They are all on the same fuse. If ANY of them work, the fuse is not blown.

i dont think that your 04 camry has a remote start unless it is an aftermarket installed keyless entry
and remote start. my 03 toyota remote has lock,unlock,trunk onfront of remote and panic button on
the back that is red.

It could be the power lock motor. You could have a short or bad wiring harness. Might just be a fuse that connects to both. But since you said it's only the driver side. When the power lock motor is bad it can trigger your alarm because they're wired together.

Hope that helps. Good luck.

maybe check the fuses or a loose wire.

should have gotten a ford lol, sorry man, its hard to say, very strange problem

The Comfort Control Module is dead.

The rear doors will not lock with the keyless remote, the drivers master switch

The keyless entry is designed to work with the doors closed (closed - not locked). If the door ajar sensor thinks the door is open the keyless entry is disabled. When you manually lock the door it might tighten the door just enough to activate the keyless entry. I would try slamming all the doors closed and then see if the keyless entry works. If it still wont work have the wiring checked on the front door lock.

Instructions to program a keyless entry remote for a Chevy Silverado. They also work on 2003, 2004 and 2006 Suburbans.

1. Close all the vehicle doors.
2. Insert the ignition key into the ignition lock cylinder.
3. Press and hold the DOOR unlock switch.
4. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
5. Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode.
6. Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to four transmitters.
8. Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode.
9. Operate the transmitter functions in order to verify correct system operation