Diagrama de caja de fusibles de jetta 97 2.0 automatico

SOURCE: Se bloque el motor al

Solamente sierra las puertas ponles el seguro desde afuera usando la llave, despues abre la puerta de el conductor, usando la llave y esto desactiva la alarma,y desbloquea el motor, la alarma se activa sola despues de desconectar la bateria por cualquier motivo, y despues cuando la conectas de nuevo , la alarma se activa automaticamente. espero y esto te ayude a resolver tu problema.

ZJ Limited

• 17989 Answers
• Posted on Oct 09, 2011

SOURCE: como coloco la banda de distribuicion de un jetta

Check this procedure...

Fig. Adjusting the belt tension on a 2.0L 8 valve

1. Disconnect the negative battery cable and remove the accessory drive belts, crankshaft pulley and the timing belt cover(s).
   
2. Temporarily reinstall the crankshaft pulley bolt and turn the crankshaft to TDC of No. 1 piston. The mark on the camshaft sprocket should be aligned with the mark on the inner timing belt cover or the edge of the cylinder head.
   
3. With the distributor cap removed, the rotor should be pointing toward the No. 1 mark on the rim of the distributor housing. On 8 valve engines, the notch on the crankshaft pulley should align with the dot on the intermediate shaft sprocket.
   
4. Loosen the locknut on the tensioner pulley and turn the tensioner counterclockwise to relieve the tension on the timing belt.
   
5. Slide the timing belt from the sprockets.

1. Check the alignment of the timing marks. On 16 valve engines, the mark on the tooth should align with the mark on the rear belt cover.
   
2. Install the new timing belt and tension the belt so it can be twisted 90 ° at the middle of it's longest section, between the camshaft and intermediate sprockets.
   
3. Recheck the alignment of the timing marks and, if correct, turn the engine 2 full revolutions to return to TDC of No. 1 piston. Recheck belt tension and timing marks. Readjust as required. Torque the tensioner nut to 33 ft. lbs. (45 Nm).
   
4. Install the belt cover and accessory drive belts.
   
5. If the belt is too tight, there will be a growling noise that rises and falls with engine speed.