SOURCE: audi a3 brake light problem.Changed fuse,bulbs and
hi check behind the light assembly itself could be its not earthing out due to corrosion your mounting screws are your earthing point it only takes water getting in behind to cause this hope this helps
SOURCE: how to adust audi a3 door, it has dropped about
if hinges are in good order, then ,with the door ajar "adjust" by grabbing hold of the bottom of the door edge and lifting upwards a little at a time to get correct fit,a common problem with heavy doors nowadays....
SOURCE: Tire pressure for a 2002
Look inside your driverside front door or door jam the manufacturer puts a label specifying tire information, what it displays is what to properly inflate the front and rear tires to as well as what tire size they recommend you use on your particular vehical....
SOURCE: whining noise from passenger front wheel had wheel bearing replaced could it be gearbox
Wierd Wheel Noises:
New bearing is actually good? Take wheel off of the ground, vehicle in neutral and rotate the wheel by hand and see that there are no problems with the bearing, CV Axle, or the brakes. And put some pressure on the bearing as much as you can to make sure it is not binding itself.
More than one bearing has been damaged during installation. I now own a 10 ton press and keep it in my basement for the next time I have to replace my bearings. Thank goodness I always buy in pairs.
Here's to hoping you just identified your problem.
If not, then: Have someone turn the wheel in both directions while watching the CV Axle at both ends, to make sure it isn't the problem.
One more issue: Swap your tires front to rear, and rear to front, and drive to see if your noise changed locations, indicating a tire or wheel problem.
If everything you just checked is working properly, then you know what's next.
Good luck !
398 views
Usually answered in minutes!
×