At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
change battery in fob --or if does not work on key then possible linkage problem which will need to slim door [ passenger side --if have aaa --service station that does lock outs locksmith notify them but need to remove door panel to access what actual problem is
depends on what you find when you take off door panel ----lock rod disconnected $0.00 to reconnect replace clip up to $5.00 for a multi pack damaged lock depends on where you get it price varies from junk yard ,online,auto store to dealer ===if someone does work add average of $65 an hr
It may be that water/moisture has gotten in behind the door panels...do you notice that it worsens in damp(er) weather? The car unlocks by itself if you leave the key in the ignition and you try and lock the doors.
Or somebody has the same coded fob (unlikely).
You might want to reprogram the remotes if you determine that the area behind the door panels is dry and there are no corroded wires, etc.
2004 Nissan Quest Remote Programming
Note: You must have all remotes on hand when performing this procedure. Any remotes not used during this procedure will become inactive.
1. Close and lock all doors with the driver's side power lock switch located on drivers door panel.
2. Insert key into ignition (DON'T TURN) and remove it from the ignition key cylinder at least 6 times within 10 seconds (this will need to be done at approximately one second intervals). You may need to insert and remove the key up to 10 or 12 times until your hazard lamps flash. PLEASE NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast or too slow the system will not enter programming mode.
3. Insert key into ignition and turn to the ACC position.
4. Within 5 seconds, push the LOCK button on the keyless remote. Your hazard lamps will flash. PLEASE NOTE: Do not press the button on the remote more than one time or the programming will not be successful.
5. If there are any remaining remotes (including working ones), Unlock then Lock all doors using the switch on drivers door panel. Within 5 seconds of locking and unlocking doors press LOCK button on the next remote. Your hazard lamps will flash. Repeat this step for each remote (including any working remotes).
6. When all remotes have been programmed turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver's side power lock/unlock switch and open the driver side door. Test all remotes.
need to remove door panel most likely problem is clip broke or popped off lock actuator clip is only a couple of bucks at most auto stores -the door panel is going to take a little bit of time since u will be working with seat and steering whel in place - u can try to see if a service station has a slim-jim [a tool that slides down into door and and unlocks doors ] or a locksmith [ more expensive ] to unlock the door so u can open door and work on it good luck
u can try to remove the rear seat...this may give u the room u need to pull the door panel off...if not u may try a service station an have them use a lock pick set to unlock the door
The only reset is if the key fob and the receiver get out of sync, to check that be out side of the car doors closed and unlocked. Press both lock and unlock buttons on the remote (key fob) at the same time if the doors lock and unlock that was your problem. It could be the battery it could be the key fob or the receiver.
×