Turn signal stays on
USA car or export, got trailer hitch options>?
front or rear mess up,
which end of car messes Up????????
say what stays on means, stuck blinking, or glows solid?
Do hazards mode fail too.>???
got trailer wiring hacks, or collision damage? (look)
Hitch jack pin 4 shorted? got factory hitch option or Uhaul hack job.
now lets do the overall view
the Module integrated power, (very expensive)
has 4 outputs for all blinkers on car, (independent)
one for each corner of car, and more if export model ( is it?)
so one hopes that MIP is not bad. $$$$
Module Integrated power (MIP for short)
it is a computer too.
so did you connect a scan tool and look for DTC errors related to BLINK(turns./Hazard)
it gets commands from the turn switch, if the turn switch works,
its ok (off it's off, & on it blinks or stick on front and or rear)
so if that is all true then the left side is bad. (front or rear? )
but you never said , front or rear.
so my answer is, replace all lamps on LEFT END OF car, that fails.
lamps can short if hug brass metal base lamps.
if new lamps fail,, then the wiring is bad, based on cost of IPM
check wires very carefull on end of car that fails.
and at hitch wires, or if had a hitch and some one hacked it in
or hack jobbed it out. (shorts)
that is it, 07 GC.
124 views
Usually answered in minutes!
×