Okay I got headlights high and low beam , can't find any fuses blown , got hazard lights , no park lights no dash lights and engine light is on jeep is running all gauges are working , no motor problems , turn signals work , all interior lights work !! Any suggestions, no fog lights or park lights

Check the wiring on that light. Also check the bulb with a couple of wires to the battery, or swap the bulb left to right to make sure the new bulb is okay.

The usual cause is a bad ground.
Check the ground with a test lamp.

i think you ment IP cluster backlights dead not warning ligts
that is real the huge parking light structures.
a blown fuse. it is, why not test them ? first.

either cab fuse or the engine bay fuse box.
12vdc on both sides of fuse, is a good fuse, key on.
100% accurate test. no guessing. ever with voltmeter.
(rare exceptions a car with a ground fuse, very rare)
so lets do this the hard way, no fuse tests......

but hark the fsm is free. why not just look at the road map er, schematic, (wiring diagrams)
lets do HL , they are hot all the time, keys lost .

your car is a TJ so having a TJ book is spiffy , no? KEEN?
lets do that. TJ wiring
click TJ
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

now click wiring, following me?
posted this 100 times,., here.

my guess is parks are dead High beams good, right, ?????
yes then go to JUMP 1.
HL dead highs and low beam? parks out.(aka TAIL)
PDF page # 92
fuse PDC #17 blown? kills cluster dead too
JUMP1: parks dead.
had lamps is fuse #1, jb (page 134 pdf)
then PDC fuse 4 and 10 (lows and highs)

PDC is engine bay box.
JB is cab box.

so my guess (hard way)
fuse 10 and CB 24 was blown. kills high/low beams
Fues1 and 4 only parks. and cluster dimmer feed.

page 134 makes all this childs play with a meter.
volt meter.

main power issues .. check battery connections.. check fuseable link wires under hood,..check fuses in fusebox for blown fuses and check wiring harnes ground connections especially by the headlights..

Get a schematic and trace out the power source to those devices not working.

check ground wire and clean connector tabs

check your fuse box on the inside is a diagram of all fuses check the one that says low beams could be blown

Day time running lights run low voltage to the high beam bulbs so it sounds to me like you need two new bulbs or you need to check the fuses and see if any need replaceing.

check the parking lights fuse

check light bulbs