Your best resource online for Dodge cars is at this website: Allpar Dodge Chrysler Plymouth Jeep and related cars minivans and trucks
SOURCE: location of the camshaft and crankshaft sensors
cam sensor is on the driver side, front of the motor, just below the valve covers in easy veiw, just outboard of the water temp sensor and they both share the same wiring harness. The cam sensor is on the passenger side, actually on the transmission bell housing. It takes the signal from the flywheel next to the ring gear, about an inch from the engine on the transmission bellhousing. Accesible from the top and easier if you remove the air filter duct. Or jack up the front passenger side and easier if you come in from the front and its behind the axel, behind the motor, go up the bell housing, just below crank shaft level. Go with this first , it tells the comp when to send fuel. If you're getting spark with a 1381 code and you're choosing between CAM & CRANK, start with this, this is the culprit. Consider getting it from the dealer. Good luck. This is Waverunner70, Hope I could help.
SOURCE: Camshaft sensor location
The cam sensor on the 4.7 is located toward the forward edge of the right cylinder head (passenger side). This has a 3 wire connector, tan/with yellow tracer is sensor signal, black / light blue tracer wire is sensor ground and the orange is the 5V supply.
SOURCE: location of camshaft sensor on a 3.5 dodge intrepid
The Camshaft Position Sensor is installed in the Timing Belt Housing Cover above the Left Camshaft Sprocket. Below is a couple of pictures...
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader.
SOURCE: location of headlight motor relay for 1989 dodge daytona
Headlight module relay located under left side of the instrument panel.
SOURCE: 2001 dodge ram 1500 5.9 camshaft position sensor
CAMSHAFT POSITION SENSOR
2001 Dodge Truck RAM 1500 1/2 ton 2WD 5.9L SFI 8cyl
The Camshaft Position Sensor is located:
Under hood, center, upper engine area, rear of intake manifold, mounted in distributor
If this is helpful.Please leave ositive Feedback. Thanks, SnugglePants
376 views
Usually answered in minutes!
×