How to reset land cruiser 200 fuel system

Question edited for clarity.
Question moved to model category.

Monitor? You mean the entertainment screen?

You go to the dealership and they will give you the code. You can't reset it, because the code it permanent. Alternative ideas in the link

https://www.google.com/search?q=2014+land+cruiser+monitor+password+reset+code

....

have you had the OBD codes read ? if not could well be code(s) P0440 P0441 P0442 P0443 P0446 and a few others ,these refer to the Evaperation control system , one easy thing to try is make sure the gas tank cap is securely tightened turning so a couple of clicks are heard , this may cure the light coming on if not will need the codes reading and further investigation keep me updated if you wish

not sure if thes will work for you but try it you wont lose any thing :

turn the key on hold the odometer button in and turn the key but don't start the engine and keep holding the button for 10 ten seconds then lift your finger off the button and the number 1 should come up now this number represents 10,000 K's so what you do is keep pushing the button until you reach the desired K's you want you can go up to 20 = 200,000 K's and then you hold the button in for another 10 seconds then let go and turn the key off and turn it back on and it should be gone i know this works because I've just done it today

It should be under vehicle, passenger side, below seating area, passenger side of transmission, mounted on frame in fuel line.
If you have not changed in a few years I would first spray with oil of some type for a week or two every day as it is probably very rusted

land cruiser
If you have trouble in fixing your vehicles, try this link. Very helpful

how to reset the fuel filter replacement warning

I want to change the engine oil in my 200 series cruiser how do I get to the sump plug & filter.

replace the IAC valve to resolve this issue.

Hi There. Have the exact same problem on my 95mod petrol with the sub fuel tank not emptying. think it may be the relay but cant find it. The earlier models have the relay in the rear wheel well, but ours are set up differently. had the whole car to pieces but still cant find it. Was wondering if you had any luck with yours and could enlighten me. Thanks [email protected]

91-97 Land Cruisers had a factory option for front and rear locking differentials. This is a seperate switch and is usually located to the left of US model Land Cruisers. The center dash button locks your transfer case differential changing your Land Cruiser from all wheel drive to four wheel drive depending if you have ABS or not this button either says ECT or Center Dif Lock. If you do not have the Front/Rear locking differential option then your Land Cruiser has open Front and Rear. Hope this answers your question.