SOURCE: abs kicks in at low speed and pedal pressure
You have a weak or bad ABS sensor on one of the hubs. They are built into the hub and are not individually replaceable. Also rust buildup around the sensor will cause this same problem. To stop the ABS from kicking in untill repair just pull the fuse.
SOURCE: abs brake warning light comes on and rear brakes remain stuck on
I would bypass abs contraption with new line.(87 dually) abs located under drivers side cab looks very susceptible and is known to fail.I would trust my foot before that old thing.Im rippin it out of my truck & replacing it with new line all the way back.Old lines rusted pretty bad.Better safe than sorry.unplug light bulb or just leave it in .Jersey cant say anything if its 94 or older at inspection.that goes for all the lights.For me,older is better.I dont know what setup you have or if you sold it, you could try replacing it for about 160 at advanced.I hope its not the computer screwin up,thats probably a dealer item.Try unpluging hydraulic unit for shits & giggles.Go over rear brakes again before you start cutting.
SOURCE: 1998 Ford Contour ABS light and one wheel partially braking
could be but not likely. sound like abs pump or abs ecu failure. to make sure check DTC's
SOURCE: 1997 ford f-150 flashing abs light (flashes 15
Does your speedometer work ok? There is a sensor on top of your rear differential that provides a signal to both the abs and the computer(speedometer uses the signal from the computer) This sensor goes out pretty common.
SOURCE: 2003 Ford Windstar Both Brake light and ABS brake light come on
Ford has a recall for this problem.
68 views
Usually answered in minutes!
×