SOURCE: cd player seems to be jammed
Well if the cd player has a reset button push it and it might kick the cd out on it's own. But if it dont then try by removing the battery cable for 1 minute. When you power most electronics they go through a self diagnostic and might just eject the cd. If that dont work then there is only two other things you can do. 1 is to take a small pair of needle nosed pliers and CAREFULLY remove the cd. But this also takes the chance that you might hit something vital and trash the cd player! 2. Uninstall the cd player and remove the top And carefully push the cd out the same way it was put in. If you do get the cd out of the player then the first thing you should do is to put in a laser eye cleaning cd and clean the player. Then see if it comes out by itself. If it does not then it is time to buy a new cd player. KENWOOD cd players are one of the few that come with a reset button that will reset the deck and remove the cd automaticly. This is a very nice option. Good luck
SOURCE: cd in car player will NOT eject -any ideas ??
The only way to fix your problem is to have a radio repair shop take it apart. You cannot fix this on your own. Remove the radio or get a quote from a repair shop first. If you cannot find a repair shop , talk to the parts guys at you local ford dealer about sending it out for repair.
SOURCE: my cd player is not loading, neither is it ejecting cds
Hi, this is a common problem with in car cd players. the shock absorber can only protect the internals from a minimal amount of shock that will be distributed from the road and normal driving situations. there is a mechanism inside the CD player(changer) that will become unstable over time. this will allow for many mechanisms that make up the unit to loosen and separate from the original structure design, in return, allowing the lens assembly to become jammed or misaligned.
When this happens, the only option is to take to a local audio electronics store like best buy. they will have audio tech in store that can disassemble the entire device to retrieve the Cd's inside. the actual cd changer itself will have to be rebuilt or replaced.
You can also take your car to the dealership for this extraction as well.
Please rate and have a great day:)
SOURCE: Bose 6 cd changer factory installed will not function.
Some people with this issue have had some sucess disconnecting the negative battery cable for 10 minutes to reset the stereo. After re-connecting the battery, the stereo should reset and the error message should clear at which point the CD player should also function. Apart from this, a service call at a dealer or a car stereo repair specialist are the only alternatives. Best of luck.
Greg
SOURCE: I have a 2001 ford escape. The cd player won't
You have a mechanism failure on the changer which is preventing the mode of the function to return to the normal state. Hence the processor is giving out the error signal. First of all open the changer and ceck for mechanism damage. if not slowl try to rotate the load motor to return to the normal state and eject. now check the connections to the motor, the flexible line wiring may be defective. use a loop wire or test the continuity from the motor. if there is a rest switch use it for resetting, if not disconnect poweer nd power again. Some cd'smay be warped or damaged and causing to block the sensitive transport. remove of these cd's and testt again. if there is no motr drive at all then the IC of the motor drive has failed. clean and set back. hope this helps you. Good day
67 views
Usually answered in minutes!
×